One Visit Crown Case Study 1

17
Case Study by Jan Frydensberg Thomsen, DDS

Transcript of One Visit Crown Case Study 1

Page 1: One Visit Crown Case Study 1

Case Study by Jan Frydensberg Thomsen,

DDS

Page 2: One Visit Crown Case Study 1

Flat top preparation

Page 3: One Visit Crown Case Study 1

Open OVC packaging

Page 4: One Visit Crown Case Study 1

Replica try in

Page 5: One Visit Crown Case Study 1

Replica try in

Page 6: One Visit Crown Case Study 1

Placing OVC Wedges

Page 7: One Visit Crown Case Study 1

Application of separating agent

Page 8: One Visit Crown Case Study 1

After cooling the OVC with spray it is placed on the prepared tooth and adjusted in the

occlusal plane. It is then spot cured through the hole in the OVC Selector Key.

Page 9: One Visit Crown Case Study 1

After the spot cure the excess material is removed.

Page 10: One Visit Crown Case Study 1

The OVC is removed and fully light-cured

Page 11: One Visit Crown Case Study 1

The margins are finished and the OVC is cleaned

Page 12: One Visit Crown Case Study 1

The clean OVC ready for cementation

Page 13: One Visit Crown Case Study 1

Etching is done

Page 14: One Visit Crown Case Study 1

The OVC is cemented with a dual cure resin cement. First spot cured through Selector Key

Page 15: One Visit Crown Case Study 1

Excess of cement is removed with a brush

Page 16: One Visit Crown Case Study 1

Finished OVC

Page 17: One Visit Crown Case Study 1