Okuma Multus U3000, 4000 2S - Sandvik Coromant · Cut-offholder,adjustable,long,IC IC80...
Transcript of Okuma Multus U3000, 4000 2S - Sandvik Coromant · Cut-offholder,adjustable,long,IC IC80...
OkumaMultus U3000, 4000 2S
Toolholder Program
OD clamping unitStandardC4-TRE-OK60A
(343-830111C375-RC)C4
StandardC4-TLE-OK60A(343-830111C375-LC)
C4
OD clamping unit, shortFor quotation343-830111C447C4
OD clamping unit, both sidesStandardC4-TRE-OK60A-DT
(343-830111C376-RC)C4
StandardC4-TLE-OK60A-DT(343-830111C376-LC)
C4
Face and ID clamping unitStandardC4-TRI-OK60C
(343-830111C1074-RC)C4
StandardC4-TLI-OK60C(343-830111C1074-LC)
C4
Face and ID clamping unit, both sidesStandardC4-TRI-OK60C-DT
(343-830111C1075-RC)C4
StandardC4-TLI-OK60C-DT(343-830111C1075-LC)
C4
Cut-off holder, adjustableStandardAPB-TNE-OK60A-25SH 32
Cut-off holder, adjustable, ICStandardIC 80
barAPBR-OK60A-25-HP(343-810100R7)
HF=25
StandardIC 80bar
APBL-OK60A-25-HP(343-810100L7)
HF=25
25.03.15Subject to change without notice
Multus U3000, 4000 2SCoromant Capto® Program
Cut-off holder, adjustable, long, ICFor quotationIC 80
bar343-810100R48(48-101968R)
HF=25
For quotationIC 80bar
343-810100L48(48-101968L)
HF=25
OD drill/milling unitStandardEC1:1C4-DNE-OK60A-E
(410104045-60)C4
StandardIC 80bar
1:1C4-DNE-OK60A-I(410104046-60)
C4
OD drill/milling unit (special offer!)For quotationEC1:1343-830820N1770
(410104039-60)C4
Face drill/milling unitFor quotationEC1:1343-830820N2613
(410504075-60)C4
For quotationIC 80bar
1:1343-830820N2614(410504076-60)
C4
Face drill/milling unit, both sidesFor quotationEC1:1343-830820N2615
(410504077-60)C4
25.03.15Subject to change without notice
Multus U3000, 4000 2SCoromant Capto® Program