Nabi DreamTab HD8 Front Panel Assembly Replacement€¦ · Position the Nabi DreamTab onto a...

Nabi DreamTab HD8 Front Panel AssemblyReplacement

Replace the front panel of the Nabi DreamTab HD8.

Written By: Ruby

Nabi DreamTab HD8 Front Panel Assemb… Draft: 2019-03-10Guide ID: 51773 -

This document was generated on 2020-11-15 06:03:35 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com of 7

INTRODUCTION

The DreamTab's durable polycarbonate case is responsible for safe enclosure of all the delicatedevice hardware. If the case itself becomes damaged, sharp plastic protrusions and exposedelectrical wiring can be a danger for young children. Replacing the case requires minimal tools,moderate strength and maximum cost efficiency.

TOOLS:iFixit Opening Tools (1)64 Bit Driver Kit (1)




https://store.ifixit.fr/products/ifixit-opening-tool

https://store.ifixit.fr/products/mako-driver-kit-64-precision-bits

Step 1 — Front Panel Assembly

Position the Nabi DreamTab onto a non-metallic surface so that the screen is facing towards theceiling, and the DreamTab logo appears closest to you.

Remove the red silicone case from the Nabi DreamTab HD8.

These steps are specific to the included manufacturer case. If you have a different protectivecase, please refer to the respective manual for removal.




Step 2

Turn it upside down, ensuring thesmall black circular camera is in theupper left hand corner.

Proceeding beyond here will voidthe manufacturer's warranty. Ifyou wish to continue, follow thesesteps carefully.

Step 3

Remove the six 2.5 mm JIS #000 screws attaching the custom grid to the back panel.




Step 4

Grasp one of the protruding squares and gently lift off the back plate. Place it aside for laterreassembly.

This piece should come off very easily. If you have trouble removing it, all of the screws may notbe completely removed. Check and proceed.

Do not confuse the golden threads for screws.

Step 5

Remove the three 3.5mm screws using the J-0 screwdriver attaching the back panel to the device.




Step 6

Rotate the top of the device towards you so that the audio jack appears on the right side of thedevice.

The audio jack will have a small symbol of headphones next to a small 3.5mm diameter hole.

Wedge the plastic opening tool between where the front and back case panels meet near theaudio jack.

Pry the device open using moderate force until you hear a clicking sound. This is the sound of theclips unlocking.

Move along the perimeter of the entire device using the same prying motion to gradually separatethe front and back panels.

Once the edges are open return to the same starting position next to the audio jack.

During this step, you may crack some parts of the case. Gently pry around the speakers, audiojack and charging cable ports to reduce this damage.




To reassemble your device, follow these instructions in reverse order.

Step 7

Once you've completed separating the front and back panels, place the device back onto the table,display facing downward and camera at the top left.

Lift off the back panel and rotate the device 180 degrees while the screen is facing down.




Nabi DreamTab HD8 Front Panel Assembly Replacement€¦ · Position the Nabi DreamTab onto a...

Documents

Transcript of Nabi DreamTab HD8 Front Panel Assembly Replacement€¦ · Position the Nabi DreamTab onto a...