Multiple SSID With Multiple VLANs configuration example on Cisco Aironet APs

By Surendra B.G TAC Engineer, Cisco Systems.

Config Check points• Assumption:- I assume that you have configured the DHCP pool on the IOS switch or

the Router or on the dedicated DHCP server.• Design:- • Assuming we have 2 VLANs (51 and 52 ) with native as 10 and mapping

to 2 different SSIDs (one and two) on any Aironet Access Points. • SSID ONE uses WEP encryption• SSID TWO uses WPA-PSK• Assuming the AP Ethernet port is connected to Gig 0/7 port of the

switch.• Broadcasting both the SSIDs.

Check Points

Step 1>> Configure the SSID and Map it to respective VLANS..

Step 2 >> Assigning the Encryption to different SSIDs with respective VLANs.

Step 3 >> Configuring the sub interface for Dot11 radio 0/1 and Ethernet.

Step 4>> Verification.

Check Point

• Switchport configuration

interface GigabitEthernet0/7 description 1141 AP IOS switchport trunk encapsulation dot1q switchport trunk native vlan 10 switchport mode trunkend

END!!!

I really appreciate your feedback

RegardsSurendra