Multi Tester - Dou Yee Enterprises · Rapport Mini features Digital multimeter. ... It built-in 2.5...
Transcript of Multi Tester - Dou Yee Enterprises · Rapport Mini features Digital multimeter. ... It built-in 2.5...
Multi Tester
Image
Model#Features
Multi Tester
Rapport MiniProfessional CCTV Tester Rapport
Rapport -10HD/PROMulti-Format Input Monitor
Rapport III / Rapport III-PROMulti Functional CCTV Tester
RA
PP
OR
T M
ini
Rapport MiniProfessional CCTV Tester Rapport
FEATURES• CCTV field monitor • Multimeter• PTZ controller• PTZ protocal analyzer
SPECIFICATIONSMODEL Rapport mini
Electronic
Characteristics
Image
PTZ Operation
Test
Multimeter
Dimension
Input Voltage
Battery
Built-in Charger
Signal System
Video In/ Out
Protocol
Transmission Speed
Transmission Mode
AC Voltage
DC Voltage
Resistance
Conitinuity
12V ±10%, above 1A
7.4V (3.7x2 )Li-Poly, 2000mAh
Charging time
Operating time
NTSC / PAL
1CH BNC , 1.0-Vpp
Multiple
2400 ~ 38400kbps
RS-422 / RS-485
4V/ 40V/300V
400mV/4V/40V/300V
400Ω/ 4KΩ /40KΩ /400K
Built-in Buzzer sound
79.1(W) x 159.3(H) x 32.2(D) mm
More than 6 hrs
More than 6 hrs(Max.8hrs)
Rapport Mini features Digital multimeter.
The Rapport Mini features full function of CCTV PTZ Controller.
The Rapport Mini features PTZ Protocol Analyzer.
It combines the most basic instrument include a voltmeter, ohmmeter and continuity tester.
It determines which protocol to control you PTZ cameras from PTZ Controller or DVR. This will guide CCTV installer to understand the protocol and find the fault device easily.
It controls & programs variety of Speed & Slow Dome cameras. This will allow CCTV installer to test or program PTZ cameras at the actual camera job site. It has multi protocol and programmable baud rate.
The Rapport Mini features color CCTV field monitor.VIDEO PAL
MODE COLORBAR CLR
PTZ LOSS
MODE SETUP DATA
PTZ ADDR 001PROTOCOL (01) PELCO-DBAUDRATE 19.2KbpsPARITY NON
::::
SPD 15
GPST 001
SPST 001
FUNC 01
MENU
FF 01 08 00 00 00 09FF 01 08 04 3F 3F 8BFF 01 08 04 3F 3F 8BFF 01 08 04 3F 3F 8B
PTZ LOSS
BACK CLEAR
Receive Data
DCV -0.000V
DCV--0.001V
METER LOSS
MODE STORE
VOLTDC BUZZAC OHM
CCTV Field Monitor
PTZ Controller
PTZ Protocol Analyzer
Multimeter
It built-in 2.5 inch color Digital Type TFT-LCD monitor, supports both PAL & NTSC video signal format. Display video signal level (IRE) is helpful to check the video quality. Brightness & Contrast control.
DIMENSIONS Unit : mm
159.3
66.5
63.8
FAROPEN
TELEOSD
NEARCLOSE WIDE
COM V/
300V 300V~MAX
V~ ~♬
MODE SET
PWRCHG
TxRx
79.1
32.2
RA
PP
OR
T-1
0HD
Rapport -10HD/PRO
Support Full HD
Multi-Format Input MonitorSPECIFICATIONS
Unit : mmDIMENSIONS266
176
38266
MODEL Rapport -10HD
Built-in
battery
Charging
time
Operating
8hours (charge only)
10hours (Working)
4~5 hours
Battery Li-ion Polymer Battery, 5000mAh/7.4V (Built-in)
1600mA (DC 12V ± 15% )
HD-SDI
CVBS
HDMI
VGA
LCD
SD/SDHC
1080p 24,25,30
1080i 50, 60
720p 50,60
NTSC / PAL
1080p 24,25,30
1080i 50, 60
720p 50,60
480i, 576p
576i, 576p
1280x1024 60,75
1280x960 60,85
1152x864 75
1024x768 60,70,75,85
800x600 60,72,75,85
10.05”, 1280x800 RGB.
Default. SANDISK 32GB (Class 10)
FAT
VIDEO
FAT16, FAT32 (Recommended)
AVI (H.264)
AUDIO
Speaker
Phone jack
Only HD-SDI & HDMI ( Support 48KHz,16bit audio bandwidth)
8 ohms 0.5W (Audio OUT)
3.5inch Stereo (Audio OUT)
266(W) x 176(H) x 38(D)Size
Electronic
characteristics
VIDEO
LCD
Storage
Storage
File System
Recording
File Format
AUDIO
Current consumption
FEATURES• Built-in 10.05" High resolution LCD• Multi Format Video Input HDMI, HD-SDI, VGA, CVBS• Auto detection input video formats• 100% Digital Processing• White LED BacklightV• 4:3 and 16:9 screen aspect ratios • User friendly GUI(Grapic user interface)• Li-ion Polymer Battery with 5000 mAh capacity• Runs 4 to 6 hours with Battery• Optical Bonding Glass with AR/AG coating (Dust Protection)• VESA standard 4 holes on the back• Mount for in-car System• Flush Type Stand• Aluminum frame• Power supply included
Suitable for HD CCTV monitor in limited space and field monitor as well.10.05", 16:9 widescreen aspect ratio without the quality loss than comes from scaling, altering an image to fit on a different screen sizeSuperb connectivity with various surveillance equipments and peripherals with the HD-SDI, CVBS, VGA ports. And the HDMI port also gives uncompressed high quality video.White LED backlight ensures natural colors from camera, DVR or others.VESA standard 4 holes on the back allows placing in car window or mounting to a wall.Dust protection optical bonding glass with AR/AG coating.Li-ion Polymer battery with 5000mA capacity runs 4 to 6 hours with battery.User-friendly GUI and intuitive and stylishly designed touch controls on the top of the sturdy aluminum case.USB port prepared for firmware update in case debugging or performance enhancement.
RA
PP
OR
T-1
0HD
HD-SDI HDMI VGA CVBS
Multi-Format Input
HD-SDI
VGA CVBS
HDMIHD-SDI
CVBS
HDMI
VGA
The multi format input monitor, which is the best for office demo, HD SDI camera test and evaluation, customer demo and exhibition or field monitor for installation of the HD SDI camera.
In the OSD menu, display setting, adjust audio volume, system of the product, and also possible to upgrade of the new firmware in the system.
The video input, power connection and audio input etc, kinds of video connected inforations are shown by the OSD (On Screen Display).
All information of the camera come in sight
A handy OSD menu
Adjust video display position
Set the Audio singal(only HD-SDI, HDMI)
Adjust brightness of LCD screen
Set the product system and firmware upgrade
Select OSD display
① Power LED ② Indicate charging status③ Power ON/OFF button.④ Selection menu
⑤ Move and select menu.⑥ MENU button⑦ MODE button ⑧ REC button
① ② ③ ④ ⑤ ⑥ ⑦ ⑧
< Rapport-10HD >
< Rapport-10HD PRO>
RAPPORT-10HD PRO, Support DVR function
[ Recorded files ][ Recording ]
REC button
RA
PP
OR
T-I
II
Rapport III / Rapport III-PROMulti Functional CCTV Tester
FEATURES• Color CCTV Field Monitor• Video Signal Generator• PTZ Protocol Analyzer• Digital Multi Meter Test & Measure Voltage, Resistance and Continuity• UTP Cable Tester Test for Direct & Cross cable, continuity, discontinuity and Shorts on UTP cable• Video Recorder• PTZ Controller Control for PTZ cameras (Pan, Tilt, Zoom and menu Setup). And also analyzing control protocol if camera control by external device.• DVR Mode (Rapport III-PRO only) MPEG4 Digital Video Recorder allows users to store video inputs on a SD card for future playback (Max. 10mins / 8files)
Unit : mm
DIMENSIONS
88
126
40
SPECIFICATIONSMODEL Rapport III / Rapport III-PRO
Electronic
Characteristics
Image
PTZ Operation
Test
UTP Cable Tester
Multimeter
Dimension
Input Voltage
Battery
Built-in Charger
Signal System
Video Level
Protocol
Transmission Speed
Transmission Mode
Tests
AC Voltage
DC Voltage
Resistance
Conitinuity
12V ±10%, above 1.2A
Lithium Polymer Battery (Inner Packaging)
Charging time
Operating time
NTSC / PAL
1.0Vp-p, 140 IRE
Multiple
2400 ~ 115.2kbps
RS-422 / RS-485
Continuity / Crossed Cable, and Breaks or Short Circuits
Max. 300V
Max. 300V
Max. 40㏁
Beeper is activated when the resistance is below 80Ω
88(W) x 126(H) x 40(D) mm
More than 6 hrs
More than 6 hrs(Max.8hrs)
PART DETAILS
BNC Video Input
RS-485 In/Out
LED Indicator
Power Input DC12V
Main Power Switch
BNC Video Output
UTP Input
SD Card Slot
PTZ Control Pad
Test Lead Port
RA
PP
OR
T-I
II
Rapport III / Rapport III-PROMulti Functional CCTV Tester
Rapport III features a UTP
Cable Tester.
Rapport III features a Digital
multimeter.
The Rapport III features full
function of CCTV PTZ Controller.The Rapport III features PTZ
Protocol Analyzer.
Its built-in 3.5 inch color Digital Type TFT-LCD monitor, supports both PAL & NTSC video signal format. Display video signal level (IRE) is helpful to check the video quality. Brightness & Contrast control.
Its outputs Color bar, Red, Blue and Green screen to allow technician to inspect video monitor or DVR. Supports both PAL& NTSC video signal format.
It combines the most basic instruments includinga voltmeter, ohmmeter and continuity tester.
It determines which protocol to control you PTZ cameras from PTZ Controller or DVR.This will guide CCTV installer to understand the protocol and find the faulty device easily.
It’s specified to quickly test a wire's comtinuity,miswiring and polarization in your network by using an attached remote terminator so you can easily test the cable whether before or after the cable is installed.
It controls & programs a variety of Speed & Slow Dome cameras. This will allow the CCTV installer to test or program PTZ cameras at the actual camera job site. It has multi protocol and a programmable baud rate.
The Rapport III features a color
CCTV field monitor.The Rapport III features a Video
signal generator.
CCTV Field Monitor Multimeter
PTZ Controller PTZ Protocol Analyzer UTP Cable tester
Video signal generatorVIDEO NTSC B C
COLOR BARVIDEO PALIRE: OmVBRIGHT 07CONTRAST 07
BACK FORMAT CLR
VIDEO PAL
MODE COLORBAR CLR
PTZ LOSS
MODE SETUP DATA
PTZ ADDR 001PROTOCOL (01) PELCO-DBAUDRATE 19.2KbpsPARITY NON
::::
SPD 15
GPST 001
SPST 001
FUNC 01
MENU FF 01 08 00 00 00 09FF 01 08 04 3F 3F 8BFF 01 08 04 3F 3F 8BFF 01 08 04 3F 3F 8B
PTZ LOSS
BACK CLEAR
Receive DataCABLE LOSS
MODE TEST
NO CONNECTION(1) XXXXX (X)(2) XXXXX (x)(3) XXXXX (X)(4) XXXXX (X)
(5) XXXXX (X)(6) XXXXX (x)(7) XXXXX (X)(8) XXXXX (X)
DCV -0.000V
DCV--0.001V
METER LOSS
MODE STORE
VOLTDC BUZZAC OHM
Rapport III features a portable DVR function.
Digital Video Recorder (Rapport III-PRO)
The Rapport III-PRO has a built-in MPEG4 Digital Video Recorder. It allows users tostore video inputs on a SD card for future playback. This ensures proper CCTV installations.
VIDEO PAL
BACK COLORBAR CLR
DISCONTINUED PRODUCTS
Rapport 337
191919191919199999991919991919191999991919991919199999991919999919199919191919199199199191919191919919919991919191919919991999199919991111111111111111111111111110000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000
8888888888888888888888888888888888888888888888888888888888888888888888888888888888888888888888888888888888888888
Rapport 337 Rapport II / Rapport II-PRO
126
4444444044444444444444444444488