Mount the Wall Bracket · Place mounting bracket over your electrical outlet. The LEFT side of the...
-
Upload
trinhthien -
Category
Documents
-
view
215 -
download
0
Transcript of Mount the Wall Bracket · Place mounting bracket over your electrical outlet. The LEFT side of the...
Plug the PetChatz® Unit into your electrical outlet with the USB type A plug on the left side. Plug the USB power supply plug into the back of your PetChatz unit. Note: Your PetChatz system includes a USB type B connector and port (see Figure A). Insert the type B cord into the type B port.
Place mounting bracket over your electrical outlet. The LEFT side of the electrical outlet should be placed with ¾” space to the LEFT side of the mounting bracket outlet opening.
4
Remove white cover and set aside. o Lift side latches upward
simultaneously. o Slide cover toward you. o Release the latches.
3
You may want to identify the location of wall studs. The wall bracket is designed to mount in the drywall but will also work mounting into a wall stud.
1
2
Mount the Wall Bracket
Identify your PetChatz mounting location and disconnect power to the electrical outlet at the main fuse box.
i If you are mounting onto a PetChatz stand or kennel door, please refer to the PetChatz Stand or Kennel Door Mounting Instructions.
¾“
PetChatz® cannot guarantee unit and pet safety if these installation instructions are not followed.
The mounting bracket has 2 screw holes on the right side and 2 screw holes on the left side of the mounting bracket. Using a pencil, mark the 4 screw holes for screw placement.
5¾“
With wall mount bracket in the proper position, secure with drywall screws into the drywall anchors and wood screws into the wall stud (as necessary).
7 8
Screw the drywall anchors in the marked locations. If you are mounting using a wall stud, use the two wood screws provided. Drilling a pilot hole is recommended.
6
¾“
iIf mounting on a horizontal electrical outlet, align the edge of the outlet
plate as shown.
ATTACH PETCHATZ UNIT TO YOUR MOUNTING BRACKET
• Using the three (3) mounting bracket screws, attach the PetChatz unit to your mounting wall bracket using a Phillips screwdriver (as shown in Figure B).
TURN ON THE PETCHATZ UNIT
• Reconnect power to the electrical outlet at the main fuse box.
• Turn on the power switch on the bottom front right side of the unit (Figure C). The PetChatz logo will display briefly on the screen. Note: It may take a few moments to power up.
• UNIT LIGHTS
o Green light to the left of Manual Treat Dispense button – Power/Online on LED.
o Amber light to the right of Manual Treat Dispense button – Low Treat LED.
Figure A
Figure C
Figure B
i If the mounting bracket does not fit over the wall plate, in some instances, the wall plate may need to be removed.