Modern Automotive Technology Chapter 76
Transcript of Modern Automotive Technology Chapter 76
Modern Automotive Modern Automotive TechnologyTechnology Chapter 76Chapter 76
Heating and Air Conditioning Heating and Air Conditioning ServiceService
2
Learning ObjectivesLearning ObjectivesVisually inspect a heating and air conditioning system and locate obvious troubles.Diagnose common heating and air conditioning problems.Describe the functions and uses of air conditioning test equipment.Locate air conditioning and heating system leaks.
Explain how to replace major heating and air conditioning components.Describe the general procedures for evacuating and charging an air conditioning system.Demonstrate safe working practices when servicing heating and air conditioning equipment.
4
Chapter 76Chapter 761. Electronic Leak DetectorsElectronic Leak Detectors locate refrigerant leaks by producing a sound or light signal.
2. A/C System EvacuationA/C System Evacuation uses a vacuum pump to remove air and moisture from the inside of the A/C system.
5
Air Conditioning SystemAir Conditioning System Leak DetectorsLeak Detectors
Ultra-Violet
Leak Detector
Electronic
Leak Detector
6
Electronic Leak DetectorElectronic Leak Detector
Produces a sound or light signal when refrigerant is detected
10
Chapter 76Chapter 763. A Bubbling Sight GlassBubbling Sight Glass indicates the
A/C system is low on refrigerant and that air is in the system.
4. A Cloudy Sight GlassCloudy Sight Glass may indicate the drying agent in the receiver-drier or accumulator has broken down and is circulating through the system.
11
Sight Glass InspectionSight Glass Inspection
Sight glass may be in the top of the receiver- drier or in the line
12
Chapter 76Chapter 765. A Schrader Type Service ValveSchrader Type Service Valve is a
spring-loaded valve, similar to the air valve in a tire.
6. Pressure Gauge AssemblyPressure Gauge Assembly typically consists of two pressure gauges, a manifold, two on-off valves, and three service hoses.
13
Schrader Service ValveSchrader Service Valve
Depressor in the service hose opens the spring-loaded valve
14
RR--134a Service Valve134a Service Valve
Attach the quick-connect fitting using the sleeve, then tighten the thumb screw to
depress the valve
16
Chapter 76Chapter 76
7. A Performance TestPerformance Test indicates A/C system condition by measuring system pressures with the engine running.
8. An AC Charging StationAC Charging Station usually contains a vacuum pump, pressure gauge set, oil injection cylinder, and a charging tank of refrigerant.
17
Performance Performance TestTest
Temperature/Pressure Chart, Note Higher Temperatures Result in Higher AC System Pressures
18
Testing a Thematic Switch/SensorTesting a Thematic Switch/Sensor
Thematic Switch
19
AC Charging StationAC Charging StationRefrigerant can be
recovered, recycled, then charged back into
the system when repairs are completed and include and usually contains a vacuum
pump, pressure gauge set, oil injection
cylinder, and a charging tank of refrigerant.
20
Chapter 76Chapter 76
9. A Stem Type Service ValveStem Type Service Valve is a manually opened and closed by screwing the valve stem in or out.
10. An OilOil--Streaked Sight GlassStreaked Sight Glass denotes low refrigerant level, which is allowing excessive compressor oil to circulate through the system.
21
StemStem--Type ValveType Valve
Manual valve that is opened and closed by
screwing the valve stem in or out
22
Servicing a FittingServicing a Fitting
Tighten leaking fittings using a torque wrench and retest for leaks. Replace the hose or line if
needed.
23
Clutch DiagnosisClutch Diagnosis
Check for voltage and ground at the clutch connector
24
Clutch DiagnosisClutch Diagnosis
Power the clutch through a jumper wire–clutch plate and pulley should lock together.
25
Learning ObjectivesLearning ObjectivesVisually inspect a heating and air conditioning system and locate obvious troubles.Diagnose common heating and air conditioning problems.Describe the functions and uses of air conditioning test equipment.Locate air conditioning and heating system leaks.
Explain how to replace major heating and air conditioning components.Describe the general procedures for evacuating and charging an air conditioning system.Demonstrate safe working practices when servicing heating and air conditioning equipment.