MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the...

15
Vehicle may differs from the model shown above DISABLED PASSENGER LIFT MIDICAR mod.MAD5800 Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595 Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Transcript of MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the...

Page 1: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Vehicle may differs from the model shown above

DISABLED PASSENGER LIFT MIDICAR mod.MAD5800

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 2: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 3: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

on IVECO EUROCARGO 140 .E28 HALF CABINENDOWED OF FEATURES COMPLY WITH FOLLOWING SPECIFICATIONS

PASSENGER COMPARTMENT Dimensions:(Approximate) Length:

Width: Height:Internal Volume:

18' (5486 mm) interior96" (2440 mm) exterior84" (2135 mm) interior966 ft3 (27.5 m3)

Structural

Front/Rear Doors:

The frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The frame is made up of channels on length sides and l·beams an width. The complete structure will be painted one Customer’s colour.

The roof will be fabricated from arched aluminum beams providing high structural integrity. lt is fused and sealed to provide completely weather tight roofing.

The flooring will be finished with anti-slip black vinyl floor covering.

Sidewalls will be aluminum exterior with reinforced studs. lnterìorwill be finished with PVC covering for easy cleaning and a sectionat the bottom of the wall will be covered with anti·skid aluminum toprotect it from damage by wheelchairs.

The entire passenger compartment will be insulated.

Two (2) 15"x24" side windows (38x61cm) on each side of the passenger compartment will be included. The windows are tinted color glass.

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 4: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Two (2) %" (19mm) doors (front & rear) will be included. Doors will slide vertically and provide an opening of 34"x77" (87x196cm). Doors will come complete with weather seals on sides, top and bottom, and interior and exterior handles. Each door will include a shatter proof tinted color window.

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 5: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Pag.2

lnteriorFinish: For proper esthetics, the interior of the passenger compartment will have

Loan Plastic finishes on the sides, front, rear, and roof, for easy cleaning, (excluding doors).

ExteriorLights: Lights and reflectors will be installed according to standards.

lnteriorLights: Van body will be fully illuminated and include two switches, one at each

end of the passenger compartment.

Accessorles: - Wheelchair restraining system adaptable to all wheelchair wheels- Wheelchair locking mechanism lever operated by hand or foot- Placement of six (6) wheelchairs- Two (2) folding seats for attendantsNote: Unit can be configured for one of the following(a) 6 wheelchairs; (b) 4 wheelchairs with 1 stretcher;(c) 2 wheelchairs & two stretchers.Tie-downs for stretchers are included.

HYDRAULIC SYSTEM (MAIN)

System will consist of:• Hydraulic pump• Electro-activated hydraulic solenoids• Twin cylinders for scissors• Four (4) cylinders for stabilizers• Pressure check points at various locations

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 6: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

• Hydraulic tank• Hydraulic line calculation will be submitted with drawings• Service shut-off valves• Gauges• Safety velocity control valves that allow va n to be lowered more slowly in case of loss of

pressure.• Manual bypass valve to lower Va n body in case of power failure• Manual hydraulic pump to raise stabilizers and return to retracted position• 1O Micron Filters• Visible oil-level and oil pressure gauges

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 7: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Pag.3

SCISSOR LIFT COMPONENTS (To raise and lower Vanbody)

Llft system: Lower Frame: Upper Frame: Scissors Arms: Pivot System:

Rolling System: Raise Capacity: Alarm:

STABILIZERS:

Twin cylinders constant smooth IIft Fabricated of "C" channels Fabricated of "C" channel Fabricated of tubular steelFabricated with bronze bushings sleeves complete with lubricating fittingsWe will supply four off-the-shelf commerciai guide rollers10,000 lbs. (4,545 kg)Sound. alarm when lowering Va nbody.

Designed to assist in wind resistance at 75 km/h.• A total. of (4) stabs will be supplied

Two {2) at rear with vertical movementTwo (2) behind driver cab with vertical movement

• Position indicator when stabs are fully extended and fully retracted.

FRONT PLATFORM Dimensions:

Length: Width:

94" (2387mm)54" (1372 mm)

(106" (2692 mm) with extendable platform)

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 8: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Door SillHeight Range: 60" (1524 mm) to 228" (5800 mm) Design

Load: Working load of 2,000 lbs. (91O kg) Floor:

Anti-skid aluminum checker plate

Railings: Sliding on sides with pad protection at each end. Hinged section farpersonnel. Safeties complete with a heavy-duty latch bar.

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 9: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Pag.4

REAR FIXED TRANSITIONAL DECK

Dimensions: Width: Length:

96" (2438mm)45 %" (1156mm)

Design: • Working load of 1,600 lbs. (727 kg)• Anti-skid aluminum tread plate floor provides sure grip.-Complete with safety railings on each side of platform and (1) ladder on the left side of platform.-Giving you more flexibility in passenger operation and safer operation from van body to platform (never have to close the door) .• the rear transitìonal deck is located between the rear door and thetail gate, it allows the crew and the attendants to access the va n body easily (i.e. no need for an access door), also the process of unloading from the van body to the ground becomes easier as the transition deck can accommodate up to two wheelchairs with an attendant!.• Also, it is used in case of emergency as the van body can be accessed through the emergency ladder fixed at the rear transitional deck.

REAR LIFT PLATFORM RAISING & LOWERING)

Dimensions: Length: Depth:

89" (2260 mm)48" + 12" ramp (1220 mm + 30.5cm ramp)

Design: - Working load of 2,000 lbs. (907 kg)- Hydraulic cylinder drive that provides a steady, smooth IIft.

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 10: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

• Anti·skid aluminum tread plate floor provides sure grip.- Toe deflector (tapered rear edge of ramp) for ease in wheelchair loading.- Safety railings on each side of platform

Lowering& Raising: Rear lift platform lowers from the passenger compartment floor leve! to

ground leve! or vice versa.

ELECTRICAL SYSTEM • Electrical system will be designed to operate on 12 VDC• All wiring will be adequately sized, fused and weatherproofed• All wiring will be coded as per our drawings• All components in a junction will be identified• All electric instruments and indicators will be easily accessible• All operating lights, standards lights and indicators will be installed as per standards

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 11: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Pag.5

SAFETY

• Vehìcle ìs equipped with a stabilizer interlock system that prevents the operator from movement during operation.

• Safety interlock preventing the stabilizers to retract when the passenger compartment is not fully lowered

• Safety interlock preventing engine to start when running• Safety rotating amber beacon light• Reverse horn• 1o lbs. Fire extinguisher• Warning devices, indicators and reflectors as per standards• Towing hooks will be fitted on the front of the vehicle• Four (4) hydraulically operated stabilizers• Emergency stop button will be installed in the passenger compartment contro! pane!

CONTROLS

Controls in Cab

• Stabilizer not retracted pilot light• Stabilìzers extend/retract button• Passenger compartment raise/lower button• Switch for flood lights• Switch for va n interior lìghts

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 12: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Passenger Compartment Controls (for fine tuning)

• Passenger compartment raise/lower button• Switch for Va nbody interior lights• Emergency kill switch• Telescopic platform extendle retract button• Air Conditioning unit controls • Communication with cab operator

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 13: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Pag.6

. TRUCK CHASSIS DESCRIPTION

Specifications:

Engine Diesel engine

Transmission Manual

Brakes Hydraulic powered

Steering Hydraulic powered

Tires as per IVECO EuroCargo provides

Front Axle 5,000 lbs (2273 kg)

Rear Axle 7,500 lbs (3,409 kg) with tapered leaf spring

Fuel Tank 18 gaL (75 lit.)

Electrical 12 VDC 95 Amps

Diego PettoriniManaging Director

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com

Page 14: MIDICAR SRL Carrozzeria Industriale Anagni -Rome Web viewThe frame is built to withstand the strains, vibrations, and other conditions incident to shipping, storage, and service. The

Note: Chassis specifications are subject to change between !ime of quoting and purchase due to upgrades based on our continuous improvement program.

Loc Paduni, Zona Asi 03012 Anagni (Fr), ITALY Tel +39 0775 769376 Fax +39 0775 769595Email: [email protected] www.midicarsrl.it www.tecnologielaziali.com