1

Saxena, Ankur

From: Steiner, JensSent: Wednesday, January 06, 2016 8:30 PMTo: Saxena, AnkurSubject: Please forward to Sathiish

Hello Sathiish! I just got to know about some changes that we have to implement into the two models C85 and C86. First, the Bridge that carries the cooling system has to be updated. The picture on the right side shows the latest version. The geometry can be found here: I:\engineering-service\CSE-FEM\FEM_ES\01_Projects\FY2016\Assembly_C85\Bridge_Cooling_System.hm

I:\engineering-service\CSE-FEM\FEM_ES\01_Projects\FY2016\Assembly_C85\ Seperation_Housing_C86_C85.hm

2

Further on, there are a couple of changes on the sidewalls: The two red marked holes on the left picture can be deleted, the latest version is the picture on the right side. The red profiles on the right picture are new, the small green marked profile on the left can be deleted.

Further changes are on the right side: The two blue marked profile on the left can replaced by the profiles shown on the right. The purple marked profile has to be shifted upwards. The yellow marked profile has to be modified. It has got a greater width on the right picture.

3

There is a small detail in the grey marked area:

And finally, the foot that carries the engine bracket has to be changed. The holes in the side wall in that region have to be changed, too.

4

These change have to be implanted to both models, C85 and C86. I´m sorry if it´s double work, but the information is brand new. In case of any questions, please give me a call. Best regards Jens Mit freundlichen Grüßen ______________________________________ Jens Steiner CLAAS Selbstfahrende Erntemaschinen GmbH CSE Virtuelle Funktionsauslegung Muensterstr. 33 33428 Harsewinkel Germany

5

Phone +49 5247 12-2071 Fax +49 5247 12-2307 mailto: jens.steiner@claas.com http://www.claas.com