May 2013 Club Scrap® Cape Codclubscrap.com/wp-content/uploads/2014/Instructions/... · May 2013...

May 2013 Club Scrap®

Cape CodMaterials:

□ Cape Cod CS® Kit with Embellishment Pack

Tools and Supplies:□ 12” Paper Trimmer□ Adhesive□ Foam Adhesive□ Tape□ 3x14” CS® Grid Ruler□ Scissors□ CS® White Pigment, Ash and India Black Inks□ Paper Piercing Tool and Cork Board

□ Hole Punch or Crop-A-Dile□ Faber-Castell White PITT Artist Pen□ Stapler and Staples□ (6) Black Mini Brads□ Craft Knife and Cutting Mat□ Black Waxed Linen Thread□ White Memories Mist□ White and Black Photo Mounting Corners

Additional Kit Items:□ Unmounted (UM) Borders & Backgrounds□ Unmounted FontArt□ Unmounted Greeting

Measurement Conversions:.125 = ⅛”

.25 = ¼”.375 = ⅜”

.5 = ½”.625 = ⅝”

.75 = ¾”.875 = ⅞”

LB = Left Base PageRB = Right Base Page

Preparation: Trim the White Printed Cutaparts into sections as indicated by the artwork. Remove the Light Grey die cuts from the parent sheet.

If you do not have an item to complete the layout as shown, simply omit or substitute the item.

Important Note: This is an advanced set of instructions. If you're new to assembly line scrapbooking, you may want to “warm up” with another collection before proceeding. Otherwise, take your time and work carefully.

All rights reserved ©2013, Club Scrap, Inc. (888) 634-9100 • www.clubscrap.com • email: [email protected]

May 2013 • Cape Cod • of 8

Layout 1 & 2

□ 12x12 Red Plain (LB)□ 12x12 Light Grey Print (RB)□ 8.5x11 White Print□ 8.5x11 Red Plain□ 8.5x11 Dark Grey Plain□ 4.25x6.25 Dark Grey Photo Matte□ Alphabet Thickers□ Light Grey Die Cuts

□ White Cutapart□ Glassine Envelope□ (2) Black Nailheads□ Silver Hook□ UM FontArt□ Striped Ribbon□ Light Grey Grosgrain Ribbon

1. Trim the 8.5x11 White Print at 5.875 and 2.375. (Separate the three vertical strips of artwork.) Trim the 2.375x11 and 2.625x11 strips into sections as indicated by the artwork. Leave the center piece intact.

2. Cut the 8.5x11 Red Plain horizontally at 10.75 and 6.25”. Trim the 6.25x8.5 horizontally at 4.25”. Use a portion of the .25x8.5 scrap of Red Plain to fill the window of the Light Grey die cut on layout #2.

3. Trim the 8.5x11 Dark Grey Plain horizontally at 6.25”. Cut the 6.25x8.5 horizontally at 4.25”. Trim the 4.75x8.5 horizontally at 6.75”. Cut the 1.75x4.75 horizontally at 4.5 and 2.25”.


4x6photo

4x6photo

4x6photo

2x1½photo

2x1½photo


Layout 3 & 4

□ (2) 12x12 White Prints (LB)□ 12x12 Green Plain (RB)□ 12x12 Dark Blue Plain□ (3) 4.25x6.25 Green Photo Mattes

□ Light Grey Die cuts□ (3) Black Mini Brads□ Light Grey Grosgrain Ribbon

1. Place one 12x12 White Print into the trimmer with the grass/fence positioned vertically at right. Cut at 11.5, 8.5, 8 and 4”. Trim one 4x12 horizontally at 6”.

2. Cut the 12x12 Dark Blue Plain at 11.5, 11, 10.5, 9.75, 8.75, 7.5, and 4.5”. Cut the 4.5x12 horizontally at 10.5, 7 and 3.5”. Trim the 1.5x4.5 horizontally at 2.25”.


4x6photo

4x6photo

6x4photo

4½x3¼photo

4½x3¼photo

4½x3¼photo


Layout 5 & 6

□ 12x12 Dark Blue Plain (LB)□ 12x12 Light Blue Print (RB)□ 12x12 Red Plain□ 8.5x11 Red Plain□ 1.375x2.625 White Print (From 1&2)□ (2) 3.375x2.625 White Prints (From 1&2)□ 2.875x2.625 White Print (From 1&2)□ (2) .5x12 White Prints (From 3&4)□ (2) 4x6 White Prints (From 3&4)

□ (2) 1.5x2.25 Dark Blue Plains (From 3&4)□ (2) 4.25x6.25 Dark Grey Photo Mattes□ (2) 4.25x6.25 Dark Blue Photo Mattes□ White Cutaparts□ Glassine Envelope□ Light Grey Grosgrain Ribbon□ White Mesh□ Stencil

1. Trim the 12x12 Red Plain at 9.25 and 6”. Cut the 6x12 horizontally at 8 and 4”.

2. Cut the 8.5x11 Red Plain horizontally at 8.5, 5.5, and 3.25”. Trim the 3.25x8.5 horizontally at 4.5”. Cut the 2.25x8.5 horizontally at 6 and 3”. Trim the 3x8.5 horizontally at 6 and 3”. Cut the 2.5x8.5 horizontally at 6 and 3”.


5¾x3¾ photo

5¾x3¾ photo

4x6photo

4x6photo

4x6photo

6x4photo

1¼x2

2x1¼photo


Layout 7 & 8

□ 12x12 Light Blue Plain (LB)□ 12x12 White Plain (RB)□ 12x12 Dark Grey Print□ 8.5x11 Dark Grey Plain□ 1.25x2.375 White Print (From 1&2)□ 2.75x2.375 White Print (From 1&2)□ (2) 3.5x2.375 White Prints (From 1&2)□ 4x12 White Print (From 3&4)

□ 1x12 Dark Blue Plain (From 3&4)□ 1.25x12 Dark Blue Plain (From 3&4)□ .75x12 Dark Blue Plain (From 3&4)□ 3x12 Dark Blue Plain (From 3&4)□ (2) 4x6 Red Plains (From 5&6)□ White Cutapart□ Alphabet Thickers□ UM FontArt and UM Borders & Backgrounds

1. Trim the 12x12 Dark Grey Print at 5”. Cut the 5x12 horizontally at 7”. The cuts will separate the print into three pieces of artwork. Use a craft knife to make a slot in the lower left corner of the 5x7 panel.

2. Trim the 8.5x11 Dark Grey Plain vertically at 4.25”. Cut each 4.25x11 horizontally at 5.5”.


5¾x3¾ photo

3¾x5¾ photo

5¼x4photo

5¼x4photo

5¼x4photo

5¼x4photo


Layout 9 & 10

□ 12x12 Light Blue Plain (LB)□ 12x12 Dark Grey Print (RB)□ 8.5x11 Dark Blue Print□ (2) 4.25x6.25 Red Plains (From 1&2)□ 4.75x6.75 Dark Grey Plain (From 1&2)□ 4x6 Red Plain (From 5&6)□ (2) 2.5x3 Red Plains (From 5&6)□ 2.5x2.5 Red Plain (From 5&6)□ 4.25x6.25 Dark Blue Photo Matte

□ 4.25x6.25 Light Grey Photo Matte□ White Cutaparts□ Light Grey Die Cuts□ Glassine Envelope□ Silver Sailboat Charm□ Light Grey Grosgrain Ribbon□ Black Nailhead□ White Photo Mounting Corners□ Black Waxed Linen Thread

1. Trim the 8.5x11 Dark Blue Print vertically at 5 and 3.5”. Cut the 3.5x11 portion without the lighthouse image horizontally at 10.5, 7 and 3.5”. Trim the 1.5x11 piece at 9”. Hide the gap between the 2x9 and 2x2” strips behind the 3.5x11 piece.


6x4photo

4x6photo

4x6photo3¾x5¾

photo

2¼x2¼photo

2¼x2¾photo

2¼x2¾photo


Layout 11 & 12

□ 12x12 Light Blue Print (LB)□ 12x12 Green Plain (RB)□ 8.5x11 Dark Blue Print□ 8.5x11 White Print□ 3.25x12 Red Plain (From 5&6)□ (2) 3x3 Red Plains (From 5&6)□ 2.5x3 Red Plain (From 5&6)□ 2.25x2.5 Red Plain (From 5&6)

□ (2) 2.25x3 Red Plains (From 5&6)□ White Cutaparts□ Glassine Envelope□ Blue Fiber□ Striped Ribbon□ Alphabet Thickers□ (2) Black Nail Heads

1. Trim the 8.5x11 Dark Blue Print vertically at 5.25”. Cut the 5.25x11 horizontally at 8.5 and 4.25”. Trim the 2.5x5.25 horizontally at 5 and 2.5”.

2. Cut the 8.5x11 White Print vertically at 5.875”. (Trim between the vertical strips of artwork.)


5x4photo

5x4photo 2¾x2¾

photo

2¾x2¾ photo

2x2¾photo

2¼x2¼photo

2¾x2¼ photo

2¾x2¼ photo


Layout 13 & 14

□ 12x12 White Plain (LB)□ 12x12 Light Grey Print (RB)□ 3.25x4 Red Plain (From 5&6)□ 5x5 Dark Grey Print (From 7&8)□ 7x12 Dark Grey Print (From 7&8)□ (3) 3.5x3.5 Dark Blue Prints (From 9&10)□ (2) 2.5x2.5 Dark Blue Prints (From 11&12)□ (2) 4.25x6.25 Light Grey Photo Mattes□ White Cutaparts□ Silver Sand Dollar Charm

□ Silver Anchor Charm□ Blue Fiber□ Striped Ribbon□ Black Photo Mounting Corners□ (2) White Nailheads □ Black Nailhead□ Black Waxed Linen Thread□ (3) Black Mini Brads□ UM Greeting

1. No trimming required for this layout. Phew! You did it! (This was a tough one.)


6x4photo

6x4photo

3¼x3¼photo

3¼x3¼photo

2¼x2¼photo

2¼x2¼photo

3¼x3photo

May 2013 Club Scrap® Cape Codclubscrap.com/wp-content/uploads/2014/Instructions/... · May 2013...

Documents

Transcript of May 2013 Club Scrap® Cape Codclubscrap.com/wp-content/uploads/2014/Instructions/... · May 2013...