Marley PVC Foam Fascia and Barge Board Complete system

Made from superior formulated uPVC foam utilising the latest technology. The molecular structure of the board’s core makes it extremely lightweight yet surprisingly tough, whilst the outer skin of the board provides rigidity, durability and a high quality maintenance-free finish. Superior in many ways to traditional materials such as wood and fibre cement, Marley’s Fas-cia and Barge Boards offer many advantages

• Lightweight cellular construction makes for easier, quicker, safer installation• Rigid PVC outer skin results in high impact resistance• Titanium treated surface means UV stability offering Ultra Violet Protection• Colourfast appearance• Flat surface with a thick top layer and high gloss need never be painted• Maintenance free design means easy cleaning with warm soapy water• Material is resistant to insects and vermin and cannot rot• Fascia and barge boards are non-flammable so will therefore not support combustion• Attractive profiles add style to your home• Cellular structure absorbs expansion in extreme heat, minimising expansion allowances• Solid Fascia Board structure will support gutter brackets

• Solid Brass Screws and Cover Caps allow for corrosion free installation with professional finish• No special tools required• The Fascia and Barge Boards are packaged in a protective film to prevent scratches before installation• A simple instruction sheet can be peeled off post installation• These products are denser to ensure durability • UV inhibitors offering Ultra Violet Protection• Scratch-free finish• Extruded in long lengths to assist with easy installation• Easy to transport• No water absorption

Fittings

• End caps available to finish off the product• Screw packs included

Advantages Over Traditional Materials

Remove existing Fascia and Barge Boards, or any other material interfering with the installation. Take care not to damage the rafter ends, and repair if already damaged or rotten.

Attach the fascia board with the solid brass screws supplied. There is no need to pre-drill a hole. If using a power driver set the torque on the lower level to avoid snapping the screw head.

Exactly the same installation procedure is used for the Barge Boards. Ensure you cut the ends of your Barge Board vertically.

Carefully measure the re-quired length of fascia.

Repeat the process for the next board.

The joining connectors for the Barge Boards work the same as the Fascia Connectors.

Transfer measurements onto the fascia to be cut. Always mark the fascia on the inside (dull side).

If the length of the required fascia means you have to join boards, make sure you measure from the inside of the connectors on either side of the gap you intend filling. Cut to size, then snap into place.

At the apex of the roof join the boards with a vertical cut. Use a plumb line if you need assistance. You can choose to fill any gaps in this join with white Silicon, but no seal is required.

Cut the fascia to the required length using a hacksaw or any saw with a fine blade. Do not use a cutting disc or grinder for this job.

When deciding where to posi-tion the joining connectors, try to centre an odd number of joints, and if possible make each fascia board length the same.

Your Fascia and Barge Boards are guaranteed for 10 years, require no painting and no maintenance.

1 2 3 4

5 6 7 8

9 10 11 12

Visit www.marleypipesystems.co.za for more information or to locate your nearest stockist or call us on +27 (0)11 739 8600

Fascia and Barge Board Step by Step Installation Guide

Barge Board Dimentions :

Width: 225mLength: 4m & 6mThickness: 9mmMass/m: 1.70 kgAverage Density: 0.55g/cm3

Fascia Board Dimentions :

Width: 225mLength: 4m & 6mThickness: 9mmMass/m: 1.36kgAverage Density: 0.55g/cm3