Making of Rings - customdesignjewellers.com.au€¦ · Making of Rings . 16/12/2015 . Starting with...
3
Making of Rings 16/12/2015 Starting with 4.5mm square 18ct Yellow and White Gold Rolling Gold to width and thickness Softening gold for setting after rolling Shaped to Diamond and 18ct Gold soldering White Gold Cap shaped ready to be soldered Look like it is meant to fit!! Softening Gold for Shank Pulling shank gold through Drawer Plates to make round Bending shank to correct size for finger
Transcript of Making of Rings - customdesignjewellers.com.au€¦ · Making of Rings . 16/12/2015 . Starting with...
Making of Rings
16/12/2015
Starting with 4.5mm square 18ct
Yellow and White Gold
Rolling Gold to width and thickness
Softening gold for setting after rolling
Shaped to Diamond and 18ct Gold
soldering
White Gold Cap shaped ready to be
soldered
Look like it is meant to fit!!
Softening Gold for Shank
Pulling shank gold through Drawer
Plates to make round
Bending shank to correct size for finger
Fiberglass hammer to get shape
without marking gold
When cut to length soldering setting
to shank
Happy so far
Shaping the Diamond band
Ready to solder
Stamping 750 (18ct) and My Logo
Filing excess off setting to shape of
ring
We go through a series of files and
Emery paper ready to polish
Emerying inside
Polishing inside
Polishing outside
First Polish ready to set Diamonds.
The Band goes off to a setter
After seating the Diamond, the edges are pushed over the stone to hold it in
Ready for final cleanup and Polish
Voila!!!
