Make a Button - Home | MSU Libraries Maker... · 2016-08-16 · button and press until it snaps...

1

Transcript of Make a Button - Home | MSU Libraries Maker... · 2016-08-16 · button and press until it snaps...

Page 1: Make a Button - Home | MSU Libraries Maker... · 2016-08-16 · button and press until it snaps down. Leave red ring in place. 5. Flip over. Place button back in the blue ring, pin

Make a Button

1. Place button front (smooth side up), artwork, and plastic cover in blue ring as shown. Ensure the top of the artwork is in line with the “TOP” label on the blue ring.

2. Use yellow ring to secure in place.

3. Flip over. Place grey ring on back of button front. With the flat side up, put the green ring on top of the grey ring and press until it snaps down.

4. Flip over. Place red ring on the front of button and press until it snaps down. Leave red ring in place.

5. Flip over. Place button back in the blue ring, pin side up. Be sure pin back cover all crimped plastic and artwork. Place green ring over pin closure. Ensure the top of the pin back is in line with the “TOP” label on the blue ring.

6. Flip over. Center assembly under button press and push handle to firmly secure. Remove the assembly to reveal your new custom button!