Maharaja GS-100 Garment Steamer - Instruction Manual - Page 05

1
DESCRIPTION 1. Steam head 2. Eject button 3. Hose connector 4. Hose 5. Carry ha nd le 6. Max level 7. Steam hose wra PPing 8. Steam head storage slide 9.a Filling in let Before use Please read the instructions for use and lmpo ant Safeguards carefullY. . Remove any packaging from the appliance. . Do not plug in or turn on until assembly is complete. .lnsert the steam hose in the hole on lhe top ol the unit while sliding out the eiect knob ' fiq.1. . Completely unwind the power cord - Iig 2 Filling with water . Your garment steamer has been designed to operate usang untreated tap water. lf your water is very hard (check with your local water authority) lt is possible to mix tap water with store-bought distilled or demineralised water in the following proportions: -50% untreated tap watet -50% distilled or demineralised water. . Fill with maximum 1 litre ofwaler, taking care that the water does not spill over - Iig.3. 9.b Em ptyihg outlet 10. On / Ofi switch 11. Electric cord storage (under base) 12. Upholstery brush" 13. Fabric brush* 14. Crease attachment" 15. Lint pad* 16, Doo r hook* vents pointing away from the doot Ensure the floor that you put the base on is a flat, stable, heat-resistant surface. . Keep the steam head on the door hook while heating up - tig.4. . Press on the On / Off switch, the power indicator light will illuminate when the garment steamer is turned on - fig.5. . Wait ,or the steam to come out. This will take approximately 2.5 minutes. . Put garment onto the door hook". . Grasp the steam head with the steam vents pointing away from you. Start steaming by lightly touching the material with the sleaming head and moving it in vertical motions " Iig,6, Begin at the top of the garment and move in an downward direction. .Steam garments holding the hose in an upright position. This allows anY condensation to Ilow back into the steamer. Use .Plug in your garment steamer. Place your garment steamer on lhe floor with the steam *ctepending on model: these accessories are either equipment specific to ceftain models or available as an optional accessory. leamer. Never Jili it

description

Maharaja GS-100 Garment Steamer - Instruction Manual

Transcript of Maharaja GS-100 Garment Steamer - Instruction Manual - Page 05

Page 1: Maharaja GS-100 Garment Steamer - Instruction Manual - Page 05

DESCRIPTION1. Steam head2. Eject button3. Hose connector4. Hose5. Carry ha nd le6. Max level7. Steam hose wra PPing8. Steam head storage slide9.a Filling in let

Before usePlease read the instructions for use andlmpo ant Safeguards carefullY.. Remove any packaging from the appliance.. Do not plug in or turn on until assembly is

complete..lnsert the steam hose in the hole on lhe top

ol the unit while sliding out the eiect knob 'fiq.1.

. Completely unwind the power cord - Iig 2

Filling with water. Your garment steamer has been designed to

operate usang untreated tap water. lf yourwater is very hard (check with your localwater authority) lt is possible to mix tapwater with store-bought distilled ordemineralised water in the followingproportions:-50% untreated tap watet-50% distilled or demineralised water.

. Fill with maximum 1 litre ofwaler, taking carethat the water does not spill over - Iig.3.

9.b Em ptyihg outlet10. On / Ofi switch11. Electric cord storage (under base)

12. Upholstery brush"13. Fabric brush*14. Crease attachment"15. Lint pad*16, Doo r hook*

vents pointing away from the doot Ensurethe floor that you put the base on is a flat,stable, heat-resistant surface.

. Keep the steam head on the door hook whileheating up - tig.4.

. Press on the On / Off switch, the power

indicator light will illuminate when thegarment steamer is turned on - fig.5.

. Wait ,or the steam to come out. This will takeapproximately 2.5 minutes.

. Put garment onto the door hook".

. Grasp the steam head with the steam ventspointing away from you. Start steaming bylightly touching the material with thesleaming head and moving it in verticalmotions " Iig,6, Begin at the top of thegarment and move in an downwarddirection.

.Steam garments holding the hose in an

upright position. This allows anYcondensation to Ilow back into the steamer.

Use.Plug in your garment steamer. Place your

garment steamer on lhe floor with the steam*ctepending on model: these accessories are either equipment specific to ceftain models or available as an

optional accessory.

leamer. Never Jili it