7/29/2019 Luna Instrucciones

http://slidepdf.com/reader/full/luna-instrucciones 1/3

* This model was designed for Papercraft and may differ from the original in some respects.

* Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.

Assembly Instructions : Three A4 sheets (No. 1 to No. 3)

name

After cutting out the hole,glue the reinforcement tothe reverse side, takingcare to ensure it doesn'tobstruct the fold lines.

Attach the red cir-cles into place atthese positions.

 F r o n t  s i d

 e  o f  t h e

  M o o n

 B a c k  s i d e  o

 f  t h e  M o

 o n

Cut out the upper half base. Use scissors tocut out the center hole. Cut out the center byfirst cutting with scissors along the red lineconnecting the center to the exterior.

Cut out the front side of the Moon (upper half)and the back side of the Moon (upper half)and glue them togetherusing the central tabs.

Glue the back side of the Moon (upper half) tothe upper half base by attaching the red circleson the back side of the Moon (upper half) intoplace on the glue tabs near the joints of theupper half base, as shown in the illustration.

 Assembling the main body of the lunar globe

1. 2. 3.

Lunar Globe : Assembly Instructions

1

7/29/2019 Luna Instrucciones

http://slidepdf.com/reader/full/luna-instrucciones 2/3

Glue the parts of the upper half together so that itsshape is semispherical. To fit the parts togethercorrectly, gently fold the tabs inward, then align thesurface features (e.g., craters) while holding the upperhalf base down with your finger and gently pulling on

the tabs. Assemble the lower half in the same way.

4.

Glue the upper half base lid to the

upper half base and the lower half base lid to the lower half base to covertheir holes.

6. Glue the upper half and the lower half 

together at the joint.7.

Fold the lid of the lower half base in half and cut outa slot so that Moon story plates can be inserted.Flatten out the lid.

5.

Reinforce the thin tabs nearthe top, using a brush orother implement to applyglue from the reverse side.

Lunar Globe : Assembly Instructions

2

7/29/2019 Luna Instrucciones

http://slidepdf.com/reader/full/luna-instrucciones 3/3

Stand 3

After folding stands 1, 2, and 3 according to

the directions, arrange the three hexagons onthe three parts so that they are positionedface to face. Glue them together so that thecolored parts facing each other face upward.

Stand 1

Stand 2

1.

Align and glue the rear surfaces of the Moonstory plates together.

2.

Insert the Moon story plates into the slot onthe lower half.

3.

 Assembling the stand

Finished!

Lunar Globe : Assembly Instructions

3