The gas turbine assembly includes the lubrication system supply and scavenge pump and the engine-mounted lube and vent system piping. The Purchaser is responsible for supplying the remainder of the system, including: oil tank, oil cooler, oil filters, and oil tank air/oil separator. The LM2500 gas turbine lubrication system is shown in the simplified schematic below. (See Reference for identification of the lubrication schematic and installation drawing.)

Details of the lube system requirements are provided in the following sections:

 

Lubrication System

Gas Turbine Lube Supply Gas Turbine Lube Scavenge

Gas Turbine Sump Pressurization and Cooling Lube System Vent

Gas Turbine Lube Drains Gas Turbine Lube System Interfaces

Materials for Gas Turbine Lube System Gas Turbine Oil Tank And Plumbing

Off Engine Lube Oil System Cleanliness Gas Turbine Approved Lubricants

Page 1 of 2Lubrication

19/11/2005http://inside-aep.ps.ge.com/insideaep/aep/iad/engine_prod_delv/idms/LM25bssac/sec09.h...

,1'(; %$&.�72�723 +20(

Page 2 of 2Lubrication

19/11/2005http://inside-aep.ps.ge.com/insideaep/aep/iad/engine_prod_delv/idms/LM25bssac/sec09.h...