ABOUT YOUR LINEA PRO 5 CHARGING CUP

GETTING STARTED

QUICK START GUIDE

PRODUCT SPECIFICATIONS

Removal

Installation

Mechanical

Compatibility: Linea Pro 5 Standard with- iPod 5th generation - iPhone 5

Linea Pro 5 w/Rugged Case with- iPod 5th generation- iPhone 5

Weight: 56 g (1.98 oz.) 57 g (2.01 oz.)

Dimensions: 74.4 mm x 57.9 mm x 29.3 mm (2.93” x 2.28” x 1.15”)

80.8 mm x 63.4 mm x 35.1 mm(3.18” x 2.50” x 1.38”)

Cable Length: 3’

Electrical

Connector: USB A

Input: 5.2V 2.4A DC

Environmental

Operating Temperature: 32°F to 95°F (0°C to 35°C)

Storage Temperature: -4°F to 113°F (-20°C to 45°C)

Linea Pro® 5Charging Cup

INSTALLATION (See Installation Diagram)

1. Ensure that the environmental conditions are within appropriate operating specifications for the charger, as well as for the Linea Pro 5 and iOS device.

2. Clip the charging cup onto the bottom of Linea Pro 5 device and check that cup is properly aligned and fully seated on the bottom of the Linea Pro 5 device.

3. Plug USB connector end of Linea Pro 5 Charging Cup into appropriate power supply (5.2V 2.4A, not included).

4. Confirm that the Linea Pro 5 LED indicator turns green to indicate charging is active.

REMOVAL (See Removal Diagram)

1. Grip the bottom of the cup with palm of hand.

2. Pull down on the rear tab with fingertips to unlock cup from device.

3. Separate the charging cup from the device.

The following table describes Linea Pro 5 Charging Cup specifications.

Please visit our website at ipcmobile.com, or contact your Infinite Peripherals account representative, for additional information about our current and future product accessory offerings.

ACCESSORIES

Mobility Sales/Technical Center Infinite Peripherals, Inc. 17681 Mitchell NIrvine, CA 92614Toll-Free: (866) 278-7860 Office: (949) 222-0300

Headquarters/Main Warehouse Infinite Peripherals, Inc. 2312 Touhy Ave.Elk Grove Village, IL 60004 Toll-Free: (800) 278-7860 Office: (847) 818-1260Fax: (847) 818-1287

Specifications subject to change without notice. Infinite Peripherals, Mobilize Your Enterprise, Linea Pro, Infinea, Infinea Tab and Infinea Omni are trademarks of Infinite Peripherals, Inc. All other trademarks are the property of their respective owners.

Technical Support Infinite Peripherals, Inc. 17681 Mitchell N Irvine, CA 92614Toll-Free: (866) 278-7860 Office: (949) 222-0300

Emailinfo@ipcmobile.com

Websiteipcmobile.com

•

Note: Box contents and part numbers may vary based on order configuration.

Infinite Peripherals does not warrant, and is not responsible for, any damage to the Linea Pro 5 Charging Cup (“Product”) as a result of liquid or solid particle intrusion into the Product or damage caused by dropping the Product. If a material or workmanship defect arises with regard to any Infinite Peripherals product, and a valid claim is received within the Warranty Period, Infinite Peripherals (at its sole discretion) will: (1) repair the Product using new or refurbished parts, or (2) replace the Product with a new or refurbished Product. For purposes of this limited warranty, “refurbished” means a product or part that has been substantially returned to its original specifications. In the event of a defect, these are your exclusive remedies.

QSG-10024 Rev. B

WARNINGS & CAUTIONSPlease observe the following precautions:

• Keep the charger away from liquids. Donot immerse the charger in water.

• The charger is intended for Indoor useonly. When not in use, place the chargerin a cool, dry place.

• Do not place the charger near a heatsource. Keep both the power supply andcharger away from direct sunlight and/orheat.

• Device should only be repaired by IPC oran authorized service facility.

• Do not use any USB connector other thanthe one provided with this charger. Theuse of any other USB connector maydamage the charger and will void thewarranty.

WARRANTY

TROUBLESHOOTING

Note: iOS device and other additional items shown on cover page may not be included.

PRODUCT RETURNSVisit our online support center at https://ipcmobile.com/support/rma. Use the link provided to create an account and gain access to our Knowledge Base and online support services. Through our online support center, you’ll be able to download files, open a Support Ticket, manage your RMAs, view your account Profile and subscribe to Alerts.

To Request a RMA:

1. Create a user account in the RMA Support Portal at https://ipcmobile. com/support/rma.

2. Login to your user account and click theCreate RMA Request option.

3. Read the instructions provided and complete the online request form.

4. Note the assigned RMA number and write it clearly on your shipping carton.

5. Ship your equipment back to us at the address provided.

ADDITIONAL INFORMATIONPlease contact your Infinite Peripherals sales representative for technical specifications and additional product documentation.

No LED illuminated on Linea Pro 5.

• The USB connector is not properlyconnected.

• The Linea Pro 5 is not seated properly inthe charging cup.

The LED is illuminated on the Linea Pro 5 upon installation but then turns off.

• Faulty charging cup.• Faulty device.