Levers ClassAct SRS enabled. In this presentation you will: identify the use of levers in hydraulic...
-
Upload
austin-alban-clarke -
Category
Documents
-
view
220 -
download
4
Transcript of Levers ClassAct SRS enabled. In this presentation you will: identify the use of levers in hydraulic...
Levers
ClassAct SRS enabled.
In this presentation you will: identify the use of levers in hydraulic applications
Levers
Next >
In this presentation you will see first, second and third class levers.
You will also see hydraulics applications where levers are used.
Levers
Mechanical Levers
Levers are simple mechanisms used to apply mechanical advantage.
A lever can be a long bar that rests on a pivot point (fulcrum). An effort is applied to move the load.
Next >
For example, by using a stiff branch resting on a log, early man was able to lift heavy rocks.
Levers
Lever Classification
There are three classes of levers. They differ in the placement of the fulcrum, effort and load along the lever.
First class lever
The three types are:
First Class
Second Class
Third Class
Second class lever
Third class lever
Next >
Sometimes these are also referred to as first order, second order and third order levers.
Levers
1
The lever shown is a:
Question
A) first class lever
B) second class lever
C) third class lever
Levers
First Class Lever
A mechanical advantage of force is achieved if the distance between the effort and fulcrum is longer than that between the load and fulcrum.
Next >
The lever will balance if the load and effort are equal, and they are also both the same distance from the fulcrum. The system is in equilibrium.
First class levers are the most common type of lever. The fulcrum is between the effort and the load.
A seesaw is an example of a first class lever. Other examples are a claw hammer, crowbar, scissors and weigh scales.
Effort
Fulcrum
Load
Levers
Second Class Levers
The load is between the effort and the fulcrum. Second class levers provide mechanical advantage of force, as the effort is always further away from the fulcrum than the load.
Next >
This allows a large load to be lifted a small distance by a smaller effort moving a larger distance.
A wheelbarrow is an example of a second class lever. Other examples include bottle openers, foot pumps and nut crackers.
Small effort,large distance
Large load,small distance
Levers
2
In a second class lever, where should the effort be placed?
Question
A) On the opposite side of the fulcrum to the load
B) On the same side of the fulcrum as the load, but further away from the fulcrum
C) Between the load and the fulcrum
D) On the opposite side of the fulcrum but very close to it
Levers
Third Class Levers
This means the effort force needs to be larger than the load, but with the advantage that the load moves a greater distance than that moved by the effort.
The effort is applied between the load and the fulcrum. The effort is closer to the fulcrum than the load.
Next >
An engine hoist is an example of a third class lever. Other examples are tweezers and fishing rods.
Effort
LoadFulcrum
Levers
3
Which of the following is an example of a third class lever?
Question
A) Wheel barrow
B) Scissors
C) Fishing rod
D) See-saw
Levers
Hydraulic Systems Using Mechanical Levers
Many construction machines make use of the hydraulic lever principle, whether they are excavating, lifting, grading, or drilling machines.
Next >
An excavator uses a hydraulic cylinder to push up the boom, but the boom is itself a type of lever. A short movement of the cylinder makes the end of the boom move much further.
First class lever Third class lever
Levers
4
On an excavator, what part of the lever mechanism does the cylinder represent?
Question
A) Load
B) Effort
C) Fulcrum
D) LeverCylinder