Lesson 14: Wiring a DC Motor
6
Wiring a DC Motor FOR LESSON 14 FROM WWW.LEARNCSE.COM
-
Upload
paul-osborne -
Category
Education
-
view
110 -
download
2
Transcript of Lesson 14: Wiring a DC Motor
![Page 2: Lesson 14: Wiring a DC Motor](https://reader035.fdocuments.in/reader035/viewer/2022062900/58ed9b4e1a28ab2e338b46d7/html5/thumbnails/2.jpg)
Step 1: Insert wires and capacitor
IMPORTANT:Do not solder yetNotice RED wire on right, BLACK on leftThe capacitor has no polarity
![Page 3: Lesson 14: Wiring a DC Motor](https://reader035.fdocuments.in/reader035/viewer/2022062900/58ed9b4e1a28ab2e338b46d7/html5/thumbnails/3.jpg)
Step 2: Solder and trim
Take care not to melt plasticTrim capacitor leads and excess
wire
![Page 4: Lesson 14: Wiring a DC Motor](https://reader035.fdocuments.in/reader035/viewer/2022062900/58ed9b4e1a28ab2e338b46d7/html5/thumbnails/4.jpg)
Step 3: Route wires under motor bracket
Take care not to bend the metal tabs on the motor
![Page 5: Lesson 14: Wiring a DC Motor](https://reader035.fdocuments.in/reader035/viewer/2022062900/58ed9b4e1a28ab2e338b46d7/html5/thumbnails/5.jpg)
Step 4: Secure wires with square knot
Tie the knot close to the nylon motor bracket. The idea is to protect the motor terminals.
![Page 6: Lesson 14: Wiring a DC Motor](https://reader035.fdocuments.in/reader035/viewer/2022062900/58ed9b4e1a28ab2e338b46d7/html5/thumbnails/6.jpg)
Step 5: Twist the red and black wires
Verify motor terminals by wiggling the red and black wires. The solder terminals on the motor should not move.