LAB 4 Shellanalysis
-
Upload
mochamad-safarudin -
Category
Documents
-
view
16 -
download
2
description
Transcript of LAB 4 Shellanalysis
0
No. Dokumen: SB/MSC/T3/ BMCS3363/3
No. Isu./Tarikh: 1/15-7-2008
VEHICLE STRUCTURE ANALYSIS 2D Plate Analysis
No. Semakan/Tarikh: 1/16-7-2008
Jum. Mukasurat
OBJECTIVES 1. To model plate structure subjected in plane force using Finite Element software. 2. To find the maximum stress and displacement of plate using Finite Element software. LEARNING OUTCOMES At the end of laboratory session, student should be able to: 1. Model a 2D plate structure using Finite Element software (Patran/Nastran) 2. Dicretize the model into several elements and nodes (meshing) 3. Apply constraints and loads to the plate structure 4. Perform linear static analysis to the plate 5. Find the maximum deformation and stress in the plate. THEORY In this lab session you will be modeling a plate subjected to in plane forces. The maximum deformation and stress will be determined using MSC.Nastran analysis software.
UNIVERSITI TEKNIKAL MALAYSIA MELAKA
1
plate
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
plate
20
21
22
plate.op2plate.f06
23
plate.op2
24
25
Questions:
1. Find the maximum displacement and maximum Von Mises Stresses on the plate 2. Make a conclusion about your lab session 3. Write a group report