L57_inst
1
Installation Instructions Version 12-2009 Copyright © MP Lighting All technical information in this document is subject to change. T 604 708 1184 mplighting.com • Read all instructions. • WARNING: RISK OF FIRE OR ELECTRICAL SHOCK: Do not make or alter any openings in the compartment of wiring or electrical components during installation. Do not alter or add ballasts, or any other electrical components. • Installation and use of this fixture mounting assembly requires a person familiar with the construction and operation of luminaire electrical systems and the hazards involved, if not qualified, do not attempt installation. • Turn off power before installation. • constant current driver only. • Do not spray water on fixture during cleaning. Avoid using detergents with hand softeners, anti-bacterial agents, glass cleaners or acrylic cleaning products. • KEEP THESE INSTALLATION INSTRUCTIONS. CAUTION Clean using a soft cloth. Maintenance 1 Drill a Ø2-1/2” (Ø63.5mm) hole. 2 3 Connect fixture wires to low voltage wiring (remote LED driver 350mA constant current). Push LED housing with friction fit spring clip into Ø2-1/2” (Ø63.5mm)hole until flush with surface. Ø63.5mm Ø2-1/2” 38mm 1-1/2” Tools not included • Phillips screwdriver Parts Qty. • LED unit • Cross countersunk screws 1 2 10mm 3/8” minimum depth Ø63.5mm Ø2-1/2” LED Housing Spring Clip 350mA LED57
-
Upload
mp-lighting -
Category
Documents
-
view
214 -
download
0
description
http://www.mplighting.com/pdf/installation/L/L57_inst.pdf
Transcript of L57_inst
InstallationInstructions
Version 12-2009
Cop
yrig
ht ©
MP
Lig
htin
g A
ll te
chni
cal i
nfor
mat
ion
in th
is d
ocum
ent i
s su
bjec
t to
chan
ge.
T 604 708 1184 mplighting.com
• Read all instructions.
• WARNING: RISK OF FIRE OR ELECTRICAL SHOCK: Do not make or alter any openings in the compartment of wiring or electrical components during installation. Do not alter or add ballasts, or any other electrical components.
• Installation and use of this fixture mounting assembly requires a person familiar with the construction and operation of luminaire electrical systems and the hazards involved, if not qualified, do not attempt installation.
• Turn off power before installation.
• constant current driver only.
• Do not spray water on fixture during cleaning. Avoid using detergents with hand softeners, anti-bacterial agents, glass cleaners or acrylic cleaning products.
• KEEP THESE INSTALLATION INSTRUCTIONS.
CAUTION
Clean using a soft cloth.Maintenance
Ø63.5mmØ2-1/2”
38mm1-1/2”
1 Drill a Ø2-1/2” (Ø63.5mm) hole.
2
3
Connect fixture wires to low voltage wiring (remote LED driver 350mA constant current).
Push LED housing with friction fit spring clip into Ø2-1/2” (Ø63.5mm)hole until flush with surface.
Ø63.5mmØ2-1/2”
38mm1-1/2”
Toolsnot included• Phillips screwdriver
Parts Qty.• LED unit• Cross countersunk screws
12
10mm3/8” minimum depthØ63.5mmØ2-1/2”
LED Housing
Spring Clip
350mA
LED57
