L101_inst
1
Installation Instructions Version 07-2009 T 604 708 1184 mplighting.com Copyright © MP Lighting All technical information in this document is subject to change. L101 • Read all instructions. • WARNING: RISK OF FIRE OR ELECTRICAL SHOCK: Do not make or alter any openings in the compartment of wiring or electrical components during installation. Do not alter or add ballasts, or any other electrical components. • Installation and use of this fixture mounting assembly requires a person familiar with the construction and operation of luminaire electrical systems and the hazards involved, if not qualified, do not attempt installation. • Turn off power before installation. • Connect to 24V DC constant voltage LED drivers only. • Do not spray water on fixture during cleaning. Avoid using detergents with hand softeners, anti-bacterial agents, glass cleaners or acrylic cleaning products. • KEEP THESE INSTALLATION INSTRUCTIONS. CAUTION CLICK CLICK Circuit Board Rail End Cap Screws Mounting plate Lens *for angled mounting plate and curved lens follow the same instructions. 1 Attach mounting plate to cove, wall, shelf or cabinetry with mounting screws (not supplied). 2 3 4 Connect circuit board rail to mounting plate. Next attach lens to circuit board rail. Fasten end-caps into C-shaped screw channels in both sides of circuit board rail. Tighten screws with Allen Key. Connect fixture wires to low voltage wiring 24V DC constant voltage drivers with 120-277V input, TLDDLV100W4100). Maintenance Clean with a soft cloth. Parts Qty. • LED rail • Cross countersunk screws • End-caps 1 4 2 Tools • Phillips screwdriver not included
-
Upload
mp-lighting -
Category
Documents
-
view
216 -
download
0
description
http://www.mplighting.com/pdf/installation/L/L101_inst.pdf
Transcript of L101_inst
InstallationInstructions
Version 07-2009
T 604 708 1184 mplighting.com
Copyright ©
MP
Lighting All technical inform
ation in this document is subject to change.
L101
•Readallinstructions.
•WARNING:RISKOFFIREORELECTRICALSHOCK:Donotmakeoralteranyopeningsinthecompartmentofwiringorelectricalcomponentsduringinstallation.Donotalteroraddballasts,oranyotherelectricalcomponents.
•Installationanduseofthisfixturemountingassemblyrequiresapersonfamiliarwiththeconstructionandoperationofluminaireelectricalsystemsandthehazardsinvolved,ifnotqualified,donotattemptinstallation.
•Turnoffpowerbeforeinstallation.
•Connectto24VDCconstantvoltageLEDdriversonly.
•Donotspraywateronfixtureduringcleaning.Avoidusingdetergentswithhandsofteners,anti-bacterialagents,glasscleanersoracryliccleaningproducts.
•KEEPTHESEINSTALLATIONINSTRUCTIONS.
CAUTION
CLICK
CLICK
Circuit Board Rail
End Cap
Screws
Mounting plate
Lens
*for angled mounting plate and curved lens follow the same instructions.
1 Attach mounting plate to cove, wall, shelf or cabinetry with mounting screws (not supplied).
2
3
4
Connect circuit board rail to mounting plate. Next attach lens to circuit board rail.
Fasten end-caps into C-shaped screw channels in both sides of circuit board rail. Tighten screws with Allen Key.
Connect fixture wires to low voltage wiring 24V DC constant voltage drivers with 120-277V input, TLDDLV100W4100).
MaintenanceClean with a soft cloth.
Parts Qty.• LED rail• Cross countersunk screws • End-caps
14
2
Tools• Phillips screwdriver not included
