iRIG: SETUP BASE PLATE - duotonesports.com · SETUP BASE PLATE When used on a board with a threaded...
Transcript of iRIG: SETUP BASE PLATE - duotonesports.com · SETUP BASE PLATE When used on a board with a threaded...
iRIG:SETUP BASE PLATE
When used on a board with a threaded hole:Make sure to remove the nut-slider.
STEP 1 / 9
When used on a board with a slider-box:Do not remove the nut-slider but loosen it so that you get the base into the box.
STEP 2 / 9
Connect the base to the board by turning it clockwise. Make sure the base sits tight on the board.
STEP 3 / 9
CONNECT THE iRIG TO THE BASE:Open the lever as indicated by the arrow.
STEP 4 / 9
Now pull the lever as indicated by the arrow to fully open the base.
STEP 5 / 9
Get the iRIG and...
STEP 6 / 9
... put the pin into the hole of the base.
STEP 7 / 9
Now push the lever back inside as indicated by the arrow.
STEP 8 / 9
Finally secure the lever in place by pushing downwards. Now you‘re ready to go!
STEP 9 / 9
HOW TO
PACKING UP:Start folding here...
...but only AFTER:1. deflating the boom-bladder
2. closing the switch between boom- and mast bladder
STEP 1 / 9
DEFLATE THE BOOM-BLADDER:Start from the back of the boom-bladder by pressing out the air with your flat handand then folding over the boom-bladder.
STEP 2 / 9
As soon as you have completely deflated the boom-bladder close the switch as indicated by the arrow.
STEP 3 / 9 STEP 4 / 9
STEP 5 / 9 STEP 6 / 9
Finish folding/rolling up the sail.
STEP 7 / 9
Finally fold the package together transversally.
STEP 8 / 9
Finished and read to go home!
STEP 9 / 9
Open the deflation valve. Now roll out the boom-bladder again .
DEFLATE THE MAST-BLADDER:Start folding over the mast-bladder from the top at the fold-marking printed onto the bladder.
Continue to folding/rolling up the sail.
iRIG:PACKING UP
HOW TO