IQ3 Configuration List
description
Transcript of IQ3 Configuration List
![Page 1: IQ3 Configuration List](https://reader036.fdocuments.in/reader036/viewer/2022082309/5467c3a8b4af9f42298b48d5/html5/thumbnails/1.jpg)
IQ3xcite configuration
1. Connect power: 100-240 Vac2. Connect to Ethernet if required( RJ 45)3. Connect inputs :-
a. Voltage input: Select V link in the link selectorb. Current input: Select I link in the link selectorc. Thermistor input: Select T link in the link selectord. Digital input : Select D link in the link selector
For more details see page 3 on IQ3xcite installation guide4. Segregate Screen Earth( Ground)5. Connect Outputs : Connect 0 and N as OV and 0-10Vdc op, If P terminal is used
connect CAREFULLY. ( P is output power of 24Vdc)6. Install I/O modules7. Connect I/O bus( for IQ3XCITE /96 and IQ3XCITE/128 only)8. NOW INSTALLATION CONFIGURATION: Switch off all power lines and isolate all
I/O. Remove cover of IQ3xcite and select Input channel Types. Now replace cover.
9. Switch ON power after finalizing all checks repeatedly.10. CHECK CONTROLLER:
a. ! = watchdog( red light): If blinking/ON: IQ faulty(Software or strategy)b. /= power(green light) : If Blinking, power supply failc. .)))= I/O bus( red light) : If on , Check I/O connection for short circuits .
11. CHECK ETHERNET after RJ45 is connected : If green is on and Yellow is blinking, IT IS WORKING, If not check Ethernet
12. CONFIGURE IQ3: Configure IQ Strategy using SET and download strategy file from SET. This downloading can be done by the following methods- a. USING ETHERNET routerb. USING LAPTOP connection RJ45 directc. Using LAN network from supervisor
13. TEST INPUTS by testing manually 14. TEST OUTPUTS by manual observation15. Connect Supervisors/ Tools / Display Panels16. IQ View can be connected directly by using RJ 11 cable provided.
Please read Manual and guide if any doubt in connections . Mushahid M