Introduction to ANSYS 5.7Part 2

Workshop Supplement

Inventory Number: 001444First Edition

ANSYS Release: 5.7Published Date: January 30, 2001

Registered Trademarks:ANSYS® is a registered trademark of SAS IP Inc.

All other product names mentioned in this manual are trademarks or registered trademarks of their respective manufacturers.

Disclaimer Notice:This document has been reviewed and approved in accordance with the ANSYS, Inc. Documentation Review and Approval Procedures. “This ANSYS Inc. software product (the Program) and program documentation (Documentation) are furnished by ANSYS, Inc. under an ANSYS Software License Agreement that contains provisions concerning non-disclosure, copying, length and nature of use, warranties, disclaimers and remedies, and other provisions. The Program and Documentation may be used or copied only in accordance with the terms of that License Agreement.”

Copyright © 2001 SAS IP, Inc.

Proprietary data. Unauthorized use, distribution, or duplication is prohibited.

All Rights Reserved.

Workshop SupplementIntroduction to ANSYS 5.7 - Part 2

January 30, 2001

Inventory #001444

3

INTR

OD

UC

TIO

N T

O A

NS

YS

5.7

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

5.7

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

5.7

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

5.7

- Part 2

Workshop Supplement

Introduction to ANSYS 5.7 - Part 2

Table of Contents

1. Array ParametersAxisymmetric WheelW1-1

2. Coupling & Constraint EquationsA. Impeller Blade (Coupling)

W2-1

B. Turbine Blade

(Constraint Equations)W2-17

C. Swaybar (Rigid Regions)W2-27

3. Working with ElementsBolt Torque

(Surface Effect Elements)W3-1

4. Beam ModelingBuilding FrameW4-1

5. SubmodelingCrank ShaftW5-1

6. Modal AnalysisU-BracketW6-1

7. Introduction to Nonlinear AnalysisArched BeamW7-1

8. Bonded ContactSwaybarW8-1

9. Macro BasicsVerifying PressuresW9-1

10. Appendix AInput Files for Workshop ExercisesA-1

* All workshops were run and verified using the first release of ANSYS 5.7