Introduction

Module 1

October 30, 2001

Inventory #001571

1-2

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

Training Manual

Introduction

Welcome!

• Welcome Part 2 of Introduction to ANSYS!

• This training course covers topics that are slightly more advanced than those presented in Part 1.

• The course is intended for all new or occasional ANSYS users regardless of actual ANSYS application.

• Several advanced training courses are available on specific topics. See the training course schedule on the ANSYS homepage: www.ansys.com under “Training Services”.

October 30, 2001

Inventory #001571

1-3

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

Training Manual

Introduction

Course Material

• The Training Manual you have is an exact copy of the slides.

• Workshop descriptions and instructions are included in the Workshop Supplement.

• Copies of the workshop files are available upon request, from your instructor.

October 30, 2001

Inventory #001571

1-4

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

INTR

OD

UC

TIO

N T

O A

NS

YS

6.0

- Part 2

Training Manual

Introduction

Course Objectives

• To apply the knowledge gained in Introduction to ANSYS Part 1 to ANSYS capabilities that are commonly used in many engineering analyses:

2. Array Parameters

3. Coupling & Constraint Equations

4. Working with Elements

5. Beam Modeling

6. Submodeling

7. Modal Analysis

8. Introduction to Nonlinear Analysis

9. Bonded Contact

10. Macro Basics