Instructions for installing the Eutron Emulator

Note:the emulator will only run on a computer where there is a LPT-port (on a laptop, for instance, will not work). Plus, this emulator causes the PC to a memory leak. Well, some of the products under them do not work!

After reading almost all of the subject, having spent about 8 hours, but still simulate the key, he decided to write a short manual. Please do not know much kick as Similar action is the first time.

This method has already been described in previous pages. I just tried to draw a conclusion from all of the above.

I do not know whether it will work in all cases, but perhaps someone will find it useful.

We have a device EUTRON SmartKey USB (Next Key).

It looks like this:

In Device Manager shows as follows:

To emulate swing archive on this link. ( http://multi-up.com/174861)It: 1. Drivers for the device. 2. Dumper, for reading the correct memory area of the device. 3. Program to create the driver of the few dump. 4. Installer driver emulation.

Actions: 1. Take out key from the computer. 2. Unpack the archive (pass: the standard). 3. We go to the folder Driver, Run sdi.exe. 4. Then turn to the LPT (Parallel) and USB remove old and put the new driver. Click the button alternately as in the figures:

>>> For the LPT (Parallel) also need to put the driver even if a key USB, otherwise the emulation is not working. At least, I have not worked as well as this written here [?]. <<<5. Close the program to install drivers. 6. Furthermore INSERT key in the computer, you must wait a bit until the wood will install. 7. Then we go in the folder Emul, Run dumper eu_pbl.exe. We wait until he is executed, and appears "Press any key to exit". Looks something like this:

Click any key. 8. Take out key from the computer. 9. After completing the program in the same folder create a file eutron.dmpIt is our desired shot dump. 10. Next start Create_Driver.bat the same folder Emul. Should look something like this:

Click any key. 11. Now in this folder, we now have another file eutron.sys. This is necessary driver to emulate the key. 12. Reserve now as it is. We go to the folder Install. Runs the file Install.bat see something like this:

. 13. The script first tries to delete the existing driver, just in case, if you set earlier, and further raises our folder Emul. 14. Overloaded. 15. After the reboot try to use the program without the key. 16. If “Opened service“ not SUCCESS you will need to correct CRC on eutron.sys before instalation (use PE Explorer or something similar)

Tested on 2 computers with XP SP3 and Win 7. Everything works.