INSTRUCTION SHEET - · PDF file7525 Cahill Road, Minneapolis, MN 55439 I 1.800.424.0796 I...
Transcript of INSTRUCTION SHEET - · PDF file7525 Cahill Road, Minneapolis, MN 55439 I 1.800.424.0796 I...
INSTRUCTION SHEET
COMFORT STOOL INSTALLATION 7525 Cahill Road, Minneapolis, MN 55439 I 1.800.424.0796 I www.sicoinc.com
Proper Installation
NO
SQUARE
TUBE
SHOWING
12"
How to Measure the Distance
""""' ......................... � ........ """"" ......... "-i:. :�
• I
Improper Installation
1.5" OF
SQUARE
TUBE_____.
SHOWING
10.5"
Proper Installation Section View of Stool Assembly
*Spacers included with Accent Guard only.
MAXIMUM TORQUE ON BOLT 200 IN POUNDS / DO NOT USE IMPACT WRENCH OR HAMMER DRILL
Tools Required:
© 2016 SICO® Inc.
13mm Socket and Drive
Ratchet
CUSTOMER CARE 1.800.424.0796
x2 (two)
284890 Rev.C
INSTRUCTION SHEET COMFORT STOOL & ACCENT GUARD INSTALLATION
7525 Cahill Road, Minneapolis, MN 55439 | 1.800.424.0796 | www.sicoinc.com
©2016 SICO® Inc. CUSTOMER CARE 1.800.424.0796 284891 Rev. C
Accent Guard Installation
1. Using two 13mm deep well sockets and drive ratchets, remove the stool by loosening the nut and bolt completely and sliding bolt out of the hole. Discard nut & bolt.
2. Slide the stool off the stool leg and place it top side down on a flat surface.
3. Place the accent guard over the stool and align the holes in the comfort stool with the holes in the accent guard.
4. Turn the screw clockwise into the aligned hole in the stool. Turn until snug.
5. Repeat Step 4 for the remaining three holes.
Stool Installation
1. Align the holes in the stool hub with the holes in the stool leg.
2. Slide the stool over the top of the stool leg.
3. Slide a spacer over the bolt, then slide bolt through the holesof the stool and stool leg. Slide second spacer over the bolt,then the nut, securing the spacers on the bolt. Tighten nut andbolt with two 13mm deep well sockets and drive ratchets.
CAUTION:
The bolt and nut must be installed to prevent excess wear on stool. Max torque on bolt: 200 in lbs.
Do not over-tighten screws.
Tools Required:x 2(two)13mm Socket &
Drive Ratchet
Accent Guard