Installing RBS6601
Transcript of Installing RBS6601
INSTALLATION INSTRUCTIONS3/1531-LZA701 Installing RBSRBS6601
6001Uen V
Copyright Ericsson AB 20102011. All rights reserved. No part of this document may be reproduced in any form without the written permission of the copyright owner. Disclaimer The contents of this document are subject to revision without notice due to continued progress in methodology, design and manufacturing. Ericsson shall
Installing
RBS8123
Connecting Transmission Interface
Ethernet, Electrical(WCDMA
and
LTE)
271124
Connecting
Transmission
Interface
Ethernet,
Optical(WCDMA
and LTE, Optional)
2.2 ToolsThe
tools
required for the installation
of
the main unit
are listedin
Table
1.Table
1
Required ToolsProduct Name Product Number
Wire Torx stripper RBS Box socket 0.2-8.6 Installing screwdriver, set
includingthe following: 43/3 T20LSA 901 Torxbit, T20 Socket, 1348ao5t)-28284(arej20)]TJ/F31Tf10809896803102742f (the)-358627eS(81/F32 mmLTT 601 138/1
Installing RBS
Installing RBS
4
Connecting the ESD Wrist Strap
Installing the Main Unit
Installing RBS
Information about grounding installation can be found in
P
Ge0622B InstallingRBS
Installing
RBSGe2038A
Connecting thePowerSupply
1. WANcable(s). 2. DUcable(s). Recommended TCU ports for cables connected to WAN and DU(s): Connect cables from TCU port ET A - ET D to WAN starting from TCU
without Installing
disconnecting RBSNote:Ensure
DC power
supply must the
that the cable.
DC power supply
be
equipped with
cable
an
has
enough extra length
toallow the removal of the main unit from external fuse
the rack
for service purposes
or
Connecting the External Alarm
9
Connecting the External AlarmThis section provides the procedure for connection to the built-in ports for external alarms and to the optional Support Alarm Unit (SAU). Note: For WCDMA and LTE, external alarms can also be connected to an RRUS as instructed in Installing Remote Radio Units.
9.1
Connecting to the Built-in Ports for External AlarmsThis section provides the procedure for connection of the external alarms to the built-in ports for external alarms.
Do!
Connecting the External Alarm
Do!
ConnectingtheSiteLAN(Optional)
InstallingRBS2. InsertthecableintoDUpositionLMT B.
Installing RBS
Connecting the On-Site Transmission System
Ge1142A
ET BET RBSGe0602D InstallingATN A
Connecting the On-Site Transmission Danger!
Installing RBS
12.5
Connecting Transmission Interface STM-1, Optical (WCDMA)This sections provides the procedures for connecting the optical STM-1 transmission interface. Ensure that the type of the cable and the SFP module on the DU match (only LC contacts applicable). Note: Handle the fiber optic cables with care and do not exceed the minimum bending radius (the fiber bending radius shall never be less than 30 mm). See the manufacturers specification for further details.
Connecting the Optical Cables from the RRU or the AIR Unit
Ge0609D
G ConnectingtheOpticalCables fromtheRRUorthe AIR Unit
Installing RBS
#
VerifyingRBS InstallationonSiteTable2 Main
UnitInstallationChecklist
Verifying RBS Installation on Site
Note:
To check the other side of the radio link, see Installing Remote Radio
Reference List