Installation Quick Guide AD400 Cylindrical 6/01/13 Doc # 109579.
-
Upload
ariel-kitchens -
Category
Documents
-
view
220 -
download
4
Transcript of Installation Quick Guide AD400 Cylindrical 6/01/13 Doc # 109579.
Step 3: Install Clutch Assembly•Remove cover plate and insert from outside•Replace cover plate
Before proceeding, verify the knob stop pin faces the edge of the door, IF NOT, re-handing is required
Step 4: Align spindle assembly based upon key cylinder type
Key in LeverCylinder
Interchangeable Core Cylinder
Turn clockwise until cam stops
Align horizontally
as shown
Step 5: Insert Key Cylinder and Lever
• For locks with key in lever cylinders, place cylinder in lever For locks with interchangeable cores, install the lever first, then
insert cylinder
• Insert key and turn 90 degrees to the right
• Push in the knob stop pin and press lever on
•Verify you can turn and remove key
Step 6: Attach the four corner posts
IMPORTANT!Verify both triangles are aligned
Step 7: Make sure triangles are aligned, insert spindle beveled side up
Step 8: Pull cable thru door as you place the lock body on the door
Step 9: Attached anti-rotation plate with two long beveled screws
Step 10: Insert the two small screws
Step 12: Place spring on spindle and insert spindle beveled side up
Step 11: Attach inside lever to interior housing
Step 12: Feed wires thru lock body as you place lock body in place
Step 13: Secure lock body in place with four screws (into the four posts on the exterior housing)
Step 14: Verify both the inside lever and the mechanical key retract the latch
Step 15: Connect ribbon cable. Make sure the RED wire is on the left
Step 16: Trim and connect door position switch wires
Step 17: Carefully slide out the clear tab from under coin cell battery
You’re Ready to Install the ReaderStep 18: Verify the gasket is properly seatedStep 19: Press reader in place
Step 20: Secure reader with two long screws Do not over tighten