Installation Instruction Mounting Pole
Transcript of Installation Instruction Mounting Pole
© Copyright 2021– Copyright Notice
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
Installation Instruction
Mounting Pole
1
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
When unboxing the mounting pole,
make sure that there are the
corresponding M8 nuts and sealing
washers on all bolts (4x). Remove them
and keep them for later.
INSTALLATION INSTRUCTION - MOUNTING POLE
2
Mounting Pole Front View Side View
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
INSTALLATION INSTRUCTION - CABLE ENTRY
3
Use the openings to insert
the power line in the
mounting pole from below
or from rear
Cable entry from below Cable entry from rear
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
INSTALLATION INSTRUCTION - EQUIPOTENTIAL BONDING CONNECTION
4
Connect the bonding conductor to the
bonding pin at the rear of the
mounting pole. Use a lug for M8 bolts
for the connection.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
INSTALLATION INSTRUCTION - CABLE RUN
5
Pass the power line through the
mounting pole until it comes out at the
top end of the pole. Make sure the line is
long enough for comfortable connection
during the following CION installation.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
INSTALLATION INSTRUCTION - FOUNDATION DRAWING
6
Mounting drill holes dia. 12 mm for M10
heavy-duty anchor A4
Bolt circle 150 mm
Oriented as shown in drawing
Foundation
Concrete according to DIN 1045-1: C30/37
XC2/XF2
Foundation neatly levelled
Foundation on frost-proof substructure
Reinforcement as required
SECTION A-A
Front
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
INSTALLATION INSTRUCTION - MOUNTING ON FOUNDATION (EXAMPLE)
7
Use the 6 drill holes and M10 heavy-duty
anchors to bolt the mounting pole to the
designated foundation (see foundation
drawing)
For example, you can use the Schrack
mounting kit (EMPUBSET--): 2x Concrete
Impact Anchor M10
*example image
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
8
INSTALLATION INSTRUCTION - PREPARE CION
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
9
INSTALLATION INSTRUCTION - PREPARE CION
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
10
INSTALLATION INSTRUCTION - MOUNTING POLE
Insert the power line through the
central pre-drilled cable gland and
fasten it on the inside in the required
length.
Then attach the CION to the
installation plate of the mounting pole
using the 4 bolts provided.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
11
INSTALLATION INSTRUCTION - ATTACH SEALING WASHERS
Slip the 4 sealing washers included in
the delivery over the mounting bolts.
They are essential for maintaining the
ingress protection rating of the charging
station. You can use a size 13 mm
socket nut to push the washers over the
bolts. You will get quite some
resistance, which is necessary to ensure
proper sealing.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
12
INSTALLATION INSTRUCTION - ATTACH M8 NUTS
Use the size 13 mm socket nut to attach
the M8 nuts included in the delivery.
Do not exceed a torque of 4.0 Nm.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
13
INSTALLATION INSTRUCTION - ATTACH SEALING PLUGS
To ensure electrical safety, attach the 4
sealing plugs included in the CION
delivery to cover the bolt holes.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
14
INSTALLATION INSTRUCTION - SUPPLY LINE CONNECTION
In this step, please make sure the
CION is securely mounted, then wire
the supply line correctly at the
terminal block.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
15
INSTALLATION INSTRUCTION - CORRECT SUPPLY LINE WIRING
CORRECT WRONG
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
16
INSTALLATION INSTRUCTION - RFID/LED BOARD CONNECTION
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
© Copyright 2021 – Urheberrechtshinweis
All content of this presentation, in particular texts, photographies and drawings, are protected by copyright laws.
Unless otherwise specified, copyrights are owned by Schreck Technik Energie GmbH. Copying or reproduction of the
content in part or in full is prohibited without prior written consent. Content must be kept confidential and restricted.
17
INSTALLATION INSTRUCTION - ATTACH COVER
In the last step, make sure the cover
is properly closed, then use the 8
plastic stainless steel screws
included in the CION delivery to
attach it with 3.0 Nm max. torque.