Installation Guide 6968 - tractorseats.com · the angle bracket from the cab deck. (You must get...

1
Installation Guide 6968 Phone: 1.800.328.1752 / Website: www.tractorseats.com Installation Instructions for KM 1057 Uni Pro Seat & Suspension in Allis Chalmers 7000 Series Tractors Technical Support 1. Remove the original seat, suspension, and slides. Also, remove the angle bracket from the cab deck. (You must get down to the bare angled cab deck.) 2. Attach the PED AC 73 by using two of the existing holes in the lower cab panel (Fig. A). Fasten with two 5/16" x 1" bolts and lock washers. 3. Drill two new holes into the vertical deck plate to correspond with the bottom holes in the pedestal support frame (Fig. B). Fasten with two 5/16" x 3/4" bolts and flange nuts. 4. Bolt the suspension assembly to the pedestal with four 5/16" x 3/4" bolts and flange nuts. 5. Bolt the seat and slide rail assembly to the suspension assembly. (Slide seat forward to access rear two holes and all the way back to access front two holes.) 6. Locate the power cable coming from the lower part of suspension and connect it to 12v power source from tractor. Optional Swivel Kit Available PN: 5007 731 Seat Top PN: 8374 PED AC 73 PN: 6019 MSG95 Suspension PN: 8078 Cut away section of tractor deck and lower cab panel. Vertical Deck Plate Fig. A Fig. B

Transcript of Installation Guide 6968 - tractorseats.com · the angle bracket from the cab deck. (You must get...

Page 1: Installation Guide 6968 - tractorseats.com · the angle bracket from the cab deck. (You must get down to the bare angled cab deck.) 2.Attach the PED AC 73 by using two of the existing

Installation Guide 6968

Phone: 1.800.328.1752 / Website: www.tractorseats.com

Installation Instructions for KM 1057 Uni Pro Seat & Suspension in Allis Chalmers 7000 Series Tractors

Technical Support

1. Remove the original seat, suspension, and slides. Also, remove the angle bracket from the cab deck. (You must get down to the bare angled cab deck.)

2. Attach the PED AC 73 by using two of the existing holes in the lower cab panel (Fig. A). Fasten with two 5/16" x 1" bolts and lock washers.

3. Drill two new holes into the vertical deck plate to correspond with the bottom holes in the pedestal support frame (Fig. B). Fasten with two 5/16" x 3/4" bolts and flange nuts.

4. Bolt the suspension assembly to the pedestal with four 5/16" x 3/4" bolts and flange nuts.

5. Bolt the seat and slide rail assembly to the suspension assembly.(Slide seat forward to access rear two holes and all the way back to access front two holes.)

6. Locate the power cable coming from the lower part of suspension and connect it to 12v power source from tractor.

Optional Swivel Kit AvailablePN: 5007

731 Seat Top PN: 8374

PED AC 73PN: 6019

MSG95 SuspensionPN: 8078

Cut away

section oftractor deck andlower cab panel.

VerticalDeck Plate

Fig. A

Fig. B