Install Manual - Banggood
Transcript of Install Manual - Banggood
![Page 1: Install Manual - Banggood](https://reader030.fdocuments.in/reader030/viewer/2022011721/61d28cdd0d1d921fa147ff00/html5/thumbnails/1.jpg)
Easythreed X1 3D Printer
Install Manual
This manual is written in accordance
with EasyThreed X1 3D printer。
Printer upgrades and equipment models
are slightly different, is a normal phenomenon,
based on the actual products received.
User’s manual inside TF card.
![Page 2: Install Manual - Banggood](https://reader030.fdocuments.in/reader030/viewer/2022011721/61d28cdd0d1d921fa147ff00/html5/thumbnails/2.jpg)
Parts List:Take out parts from package , check if all parts have as listed below。
`
1. Install the XZ Axis set to the Printer Base.
1. Put Z-axis motor wire through this hole
2. Install it downward in the direction of this arrow
![Page 3: Install Manual - Banggood](https://reader030.fdocuments.in/reader030/viewer/2022011721/61d28cdd0d1d921fa147ff00/html5/thumbnails/3.jpg)
2.After insert the XZ Axis, Fixed with 2 screws.
3. Connect the Z-axis motor line to the output line of the printer control box as
shown in the figure below..
Z-axis motor end-to-end docking
Fixed with screws
![Page 4: Install Manual - Banggood](https://reader030.fdocuments.in/reader030/viewer/2022011721/61d28cdd0d1d921fa147ff00/html5/thumbnails/4.jpg)
4.Install the Filament Holder as below.
Important Notice:This filament holder can only hang on 250g weight filament.
connect the power and start the 3D printing journey.。
ShenZhen EasyThreed Technology CO.,LTD
http://www.easythreed.com [email protected]