In-building Public Safety - Cel-Fi

2
2 Hour Fire Rated Riser Network Unit Coverage Unit Coverage Unit FIRE ROOM 700 / 800 Donor Antenna FirstNet Donor Antenna FACU NU MBBU CU CU Power-off Switch Main Fire Control Panel Annuniciator Panel COAX RF Cat5e Form-C Cable 24 PIN EPO: Emergency Power Off Button RA: Remote Annunciator MBBU: Monitor and Backup Battery Unit FACU: Fire Alarm Control Unit NU: Network Unit CU: Coverage Unit LEGEND EPO RA • Class A with 56 Channels • Class B with 26 Channels • Scalable up to 200K sq. ft. coverage per Coverage Unit • 700/800 MHz for Public Safety with dedicated FirstNet Automatic calculation and set of isolation • Automatic Uplink / Downlink calculation • Talk-out Guarantee Scalable All-Digital PoE / RFoE • Built-in Remote Monitoring SAVING LIVES Built for Integrators, AHJs, and Building Owners Get a Faster Certificate Occupancy with the Most Advanced Public Safety ERCES Solution Available In-building Public Safety Performance Leadership Ease of Install Leaders in Value Fastest Project Timeline Code Compliant

Transcript of In-building Public Safety - Cel-Fi

2 Hour Fire RatedRiser

NetworkUnit

CoverageUnit

CoverageUnit

FIRE ROOM

700 / 800 Donor Antenna

FirstNet Donor Antenna

FACU

NU

MBBU

CU

CU

Power-off Switch

Main FireControl Panel

AnnuniciatorPanel

COAX RFCat5eForm-C Cable 24 PIN

EPO: Emergency Power Off ButtonRA: Remote AnnunciatorMBBU: Monitor and Backup Battery UnitFACU: Fire Alarm Control UnitNU: Network UnitCU: Coverage Unit

LEGEND

EPO

RA

• Class A with 56 Channels• Class B with 26 Channels• Scalable up to 200K sq. ft.

coverage per Coverage Unit • 700/800 MHz for Public

Safety with dedicated FirstNet• Automatic calculation and set of

isolation• Automatic Uplink / Downlink

calculation• Talk-out Guarantee• Scalable All-Digital PoE / RFoE• Built-in Remote Monitoring

SAVING LIVESBuilt for Integrators, AHJs, and Building Owners

Get a Faster Certificate Occupancy with the Most Advanced Public Safety ERCES Solution Available

In-building Public Safety

Performance Leadership

Ease of Install

Leaders in Value

Fastest Project Timeline

Code Compliant

brief_quatra-red_21-0504

Which public safety configuration do you need for your building?

cel-fi.comU.S. Headquarters: Nextivity Inc.16550 West Bernardo Drive, Bldg. 5, Suite 550, San Diego, CA 92127, USA+1 858.485.9442 tel • +1 858.485.9445 fax

Cel-Fi QUATRA RED — BDA Configuration (up to 400,000 sq. ft.)A single Cel-Fi QUATRA RED Coverage Unit supplies 1W per band, with one RF output that delivers combined FirstNet and LMR signals. Two CUs can be attached to a single NU for a 1W or 2W configuration powered by the small version of the MBBU that supports 12 or 24 hours back up requirements.

Cel-Fi QUATRA RED — DAS Configuration (up to 1.2 Million sq. ft.)In this configuration the CUs can be installed right where the coverage is needed with virtually zero cable loss thanks to the power and RF over Ethernet capabilities in Cel-Fi QUATRA RED. No additional battery backup power is required at the remote location, drastically reducing time and cost of installation. Each Network Unit (NU) is capable of scaling up to 6-Watts by adding 6 Cel-Fi QUATRA RED Coverage Units (CU) to the NU.

Cel-Fi QUATRA RED — Campus Configuration (up to 3 Million sq. ft.)By using fiber to connect Cel-Fi QUATRA RED Network Units (NU) it is possible to configure this system to cover an entire campus. Expand your configuration with a scalable, (up to 12-Watt) solution by adding a Cel-Fi Fiber Hub to connect building to building. 

Cel-Fi QUATRA RED — Cellular & Public Safety ConfigurationDuring emergency situations it is critical to have working Public Safety Communications as well as reliable in-building cellular coverage. Combining Cel-Fi QUATRA RED and Cel-Fi QUATRA systems in one building ensure you have both critical communication systems covered.

Sometimes Public Safety ERRCS solutions are not one-size-fits-all. Determining factors like regulations and building size play a huge role as to which solution is the best fit. At Cel-Fi we have created a scalable, all-in-one system to be adaptable and accommodate all your needs.

Network Unit (NU): Supports 700/800 LMR + FirstNet bands 14, 12, 4 and 2. Up to six CUs can be attached to a single NU. Dedicated donor ports for LMR and LTE. Class A and Class B versions available.

Coverage Unit (CU): 1 watt output power for each LMR band. Class A device with 56 channels and Class B unit with 28 bandwitdh variable filters for both 700 & 800 bands. PoE ready. N type port to distribute RF signals.

Emergency Power Off (EPO): Shuts-off the radio system in case risk of explosion or interfer-ence with the network.

Monitoring & Battery Backup Unit (MBBU):Supports 12hrs or 24hrs battery back up configurations. Front panel alarm, with LTE modem built-in. Two sizes for small and large configurations.

Remote Annunciator (RA): Supports 12hrs or 24hrs battery backup configurations. Front panel alarm, with LTE modem built-in. Three sizes for small, large and extra large configurations.

CLASS A: F42-67ENUCLASS B: F42-67ENUB

F42-10E-100

F42-10S-100F42-10L-100F42-10X-100

CLASS A: F41-8XCUCLASS B: F41-8XCUB

F42-10R-100

Scalable All-in-One Solution Elements:

Code Compliant• IFC 510• NFPA 1221 • UL 2524

Conforms toUL STD 2524

5003908