Datasheet

14 October 2013 1

PATA EDOM EDM6D-HR/ EDM6D-HL

SA6XXXXRE- FXXXXXXX

ACPi Digital Co., Ltd. TEL: 886-2-7731-5188 FAX: 886-2-7731-5288 E-mail: sales@acpigroup.com Address: 11F.-3, No.186, Jian 1st Rd., Zhonghe Dist., New Taipei City 235, Taiwan (R.O.C.) www.acpigroup.com

Datasheet

14 October 2013 2

Table of Contents

1.1 INTRODUCTION __________________________________________________________________________________ 3

1.2 GENERAL DESCRIPTION ___________________________________________________________________________ 3

1.3 FEATURES _______________________________________________________________________________________ 3

1.4 SPECIFICATIONS _________________________________________________________________________________ 4

1.5 BLOCK DIAGRAM _________________________________________________________________________________ 5

1.6 PIN SIGNAL DEFINITION ___________________________________________________________________________ 6

2. GENERAL PRODUCT SPECIFICATIONS ________________________________________________________________ 7

2.1 INTERFACE ______________________________________________________________________________________ 7

3. PHYSICAL CHARACTERISTICS _______________________________________________________________________ 8

3.1 MECHANICAL ____________________________________________________________________________________ 8

4. ENVIRONMENTAL SPECIFICATION ___________________________________________________________________ 9

4.1 TEMPERATURE _________________________________________________________________________________ 11

4.2 VIBRATION _____________________________________________________________________________________ 11

4.3 SHOCK ________________________________________________________________________________________ 11

4.4 REGULATIONS __________________________________________________________________________________ 11

5. ORDERING INFORMATION ________________________________________________________________________ 12

6. CONTACT INFORMATION _________________________________________________________________________ 12

Datasheet

14 October 2013 3

1. Introduction

1.1 General Description

The Horizontal PATA DOM in a IDE-PATA-44pin interface Disk On Module that feature a flash

disk controller chip and NAND type flash memory devices. The EDM6C-Hx is available in 128MB

to 16GB capacities in PATA DOM Horizontal type. The drives operate in 5-volts power supply

and support ATA PIO mode 6, MDMA mode 4, UDMA mode 4 data transfer. The Disk On

Module is geared specifically to the industrial market for use in such products as ATM, factory

automation machines, POS terminals, measuring products, ticket-vending machines, parking

systems and other industrial product that require high tolerance to environmental condition.

1.2 Features

Memory Capacities (SLC):

128MB

256MB

512 MB

1GB

2GB

4GB

8GB

Horizontal left or right 44PIN connector

High performance

Dual Mode

Sequential Read: Up to 38.8 MB/sec

Sequential Write: Up to 27.8 MB/sec

Single Mode

Sequential Read: Up to 19.8 MB/sec

Sequential Write: Up to 13.8 MB/sec

Low Power consumption

Supply Voltage：5.0v ± 5 %

Typical read：max. 156.3mA

Typical write：max. 172.8mA

Typical idle：1.59mA

Highly reliable

Mean time to failure (MTTF) ：2,000,000 hours, based on Part Stress Analysis

Data reliability：Built-in ECC function

Datasheet

14 October 2013 4

Operating shock：1,500G, 0.5msec half sine

Operating vibration：2.17G, 7-500Hz

Operating Temperature

Commercial: -0°C to + 70°C

1.3 Specifications

Form Facto：44pin Horizontal PATA DOM no housing

Density：128MB up to 16GB

Dimension：48mm x 30mm x 5.4mm

Interface：Compatible with devices that support the ATA-6 Attachment (with Ultra DMA

4 support) for Disk Drives Standard.

Connector：IDE PATA 44 pins

Power Supply：5V ± 5 %

Package：none

OS Support：All

Datasheet

14 October 2013 5

1.4 Block Diagram

Datasheet

14 October 2013 6

1.5 Pin Signal Definition

Pin Name Description Pin Name Description

1 RESET Host to device reset 2 GND Power GND

3 DATA7 Data Bus bit 7 4 DATA8 Data Bus bit 8

5 DATA6 Data Bus bit 6 6 DATA9 Data Bus bit 9

7 DATA5 Data Bus bit 5 8 DATA10 Data Bus bit 10

9 DATA4 Data Bus bit 4 10 DATA11 Data Bus bit 11

11 DATA3 Data Bus bit 3 12 DATA12 Data Bus bit 12

13 DATA2 Data Bus bit 2 14 DATA13 Data Bus bit 13

15 DATA1 Data Bus bit 1 16 DATA14 Data Bus bit 14

17 DATA0 Data Bus bit 0 18 DATA15 Data Bus bit 15

19 GND Power GND 20 KEY PIN For protect pin

21 NC No connect 22 GND Power GND

23 IOW Host I/O write 24 GND Power GND

25 IOR Host I/O read 26 GND Power GND

27 IORDY Host I/O ready 28 NC No connect

29 NC No connect 30 GND Power GND

31 IRQ Host interrupt request 32 IOCS16 I/O chip select 16 bits

33 A1 Device addressing bit 1 34 PDIAG Pass diagnostics

35 A0 Device addressing bit 0 36 A2 Device addressing bit 2

37 CS0 Host chip select bit 0 38 CS1 Host chip select bit 1

39 DASP During the reset protocol 40 GND Power GND

41 VCC POWER +5V 42 VCC POWER +5V

43 GND Power GND 44 NC No connect

Datasheet

14 October 2013 7

2. General Product Specifications

2.1 Interface

The PATA DOM interface compiles with the following standards:

PIO mode 4

MDMA 2

UDMA 4

The PATA DOM supports Ultra DMA-4 66MB/sec interface rate.

2.2 Wear-leveling

Global Wear-Leveling

2.3 Humidity

Operating Humidity (30ºC Max. Wet Bulb Temp): 10% to 95%

Non-Operating Humidity (30ºC Max. Wet Bulb Temp): 10% to 95% (with no condensation relative

humidity)

2.4 Read and Program/Erase Cycle

Program/Erase: 2,000,000 cycles with 2% of device capacity data size (max.)

Datasheet

14 October 2013 8

3. Physical Characteristics

3.1 Mechanical

Parameter Specifications

Width 32.6mm ± 0.2mm

Length 48mm ± 0.2mm

Height 13.4mm ± 0.15mm

Datasheet

14 October 2013 9

4. ATA Command Set

No COMMAND Code FR SC SN CY DH LBA

1 Check Power Mode E5h or 98h - - - - D -

2 Erase Sector(s) C0h - Y Y Y Y Y

3 Execute Drive Diagnostic 90h - - - - D -

4 Flush Cache E7h - - - - D -

5 Format Track 50h - Y - Y Y Y

6 Identify Device ECh - - - - D -

7 Identify Device DMA EEh - - - - D -

8 Idle E3h or 97h - Y - - D -

9 Idle Immediate E1h or 95h - - - - D -

10 Initialize Drive Parameters 91h - Y - - Y -

11 Media Lock DEh - - - - D -

12 Media Unlock DFh - - - - D -

13 NOP 00h - - - - D -

14 Read Buffer E4h - - - - D -

15 Read DMA C8h - Y Y Y Y Y

16 Read Long Sector 22h or 23h - - Y Y Y Y

17 Read Multiple C4h - Y Y Y Y Y

18 Read Native Max Address F8h - - - - D -

19 Read Sector(s) 20h or 21h - Y Y Y Y Y

20 Read Verify Sector(s) 40h or 41h - Y Y Y Y Y

21 Recalibrate 1Xh - - - - D -

22 Request Sense 03h - - - - D -

23 Seek 7Xh - - Y Y Y Y

24 Set Features EFh Y - - - D -

25 Set Max Address F9h - Y Y Y Y Y

26 Set Multiple Mode C6h - Y - - D -

27 Set Sleep Mode E6h or 99h - - - - D -

28 SMART B0h Y Y - Y Y -

29 Standby E2h or 96h - - - - D -

30 Standby Immediate E0h or 94h - - - - D -

31 Translate Sector 87h - Y Y Y Y Y

32 Write Buffer E8h - - - - D -

33 Write DMA CAh - Y Y Y Y Y

34 Write Long Sector 32h or 33h - - Y Y Y Y

35 Write Multiple C5h - Y Y Y Y Y

36 Write Multiple w/o Erase CDh - Y Y Y Y Y

37 Write Sector(s) 30h or 31h - Y Y Y Y Y

38 Write Sector(s) w/o Erase 38h - Y Y Y Y Y

39 Write Verify 3Ch - Y Y Y Y Y

Definitions:

FR = Features Register

CY = Cylinder Registers

Datasheet

14 October 2013 10

DH = Device/Drive/Head Register

LBA = Logical Block Address Mode Supported (see command descriptions for use).

Y - The register contains a valid parameter for this command. For the Drive/Head Register Y means

both the device and head parameters are used.

D - only the device parameter is valid and not the head parameter; C – The register contains

command specific data (see command descriptions for use).

Datasheet

14 October 2013 11

5. Environmental Specification

5.1 Temperature

Parameter Temp Specifications

Operating Normal Temp 0°C to 70°C

Storage -40°C to 85°C

Operating Wide Temp -40°C to 85°C

Storage -55°C to 95°C

Maximum temperature gradient 30°C per hour

5.2 Vibration

Parameter Specifications

Operating 20G , 7 - 2000HZ

5.3 Shock

Parameter Acceleration Force

(G)

Half-sine Pulse Duration

(msec)

Operating 500 2

1,000 1

1,500 0.5

Non-Operating 200 10

1,500 1

1,500 0.5

5.4 Regulations

EMC

Directive 73/23/ECC for product safety

Directive 89/336/EEC

FCC

FCC 47CFR part 15 subpart B Class B.

BSMI

CE

RoHs

Datasheet

14 October 2013 12

6. Ordering Information

P/N Capacity(Max) Remark

CDC128MRI-F003A009 128MB

Toshiba SLC Normal-Temp

CDC256MRI-F103A009 256MB

CDC512MRI-F203A005 512MB

CDC001GRI-F303A005 1GB

CDC002GRI-F403A005 2GB

CDC004GRI-F403A005 4GB

CDC008GRI-F403A005 8GB

CDI128MRI-F003A009 128MB

Toshiba SLC Wide-Temp

CDI256MRI-F103A009 256MB

CDI512MRI-F203A005 512MB

CDI001GRI-F303A005 1GB

CDI002GRI-F403A005 2GB

CDI004GRI-F403A005 4GB

CDI008GRI-F403A005 8GB

7. Contact Information

A+CPI, a storage business company, specializes in the design and marketing of SSD, EDM, and

Industry CF products.

For further information, please reach us at the following contact information:

ACPi Digital Co., Ltd. TEL: 886-2-7731-5188 FAX: 886-2-7731-5288 E-mail: sales@acpigroup.com Address: 11F.-3, No.186, Jian 1st Rd., Zhonghe Dist., New Taipei City 235, Taiwan (R.O.C.) www.acpigroup.com