HS Compact Handheld Transmitter Master Development System

Quick Start Reference

Remove Contents

Remove the decoder board, transmitters, antenna and battery.

1 Set Up the Decoder Board

Install the antenna and battery onto the decoder board.

2

Press Buttons on the Transmitter to Enable Decoder Board4

Turn On Power3

Revised 7/31/2015

Turn on the power to the board.

Decoder Board

LEDs

Changing the Transmitter Address

Create an Encryption Key1 Hold the Boards Close2

Put Decoder into Learn Mode3

Hold the LEARN button and press the CREATE_KEY button. The MODE_IND LED turns on. Release the LEARN button and press the CREATE_KEY button ten times until the LED turns off to generate the KEY.

Use a paperclip to press the IR Enable button through the top hole on the back of the transmitter. Hold the back of the transmitter close to the IR sections of the decoder board. The MODE_IND LEDs on both boards light up when the key is successfully transferred. The decoder sends the key for up to 15 seconds after generation.

Press the LEARN button on the decoder board and the MODE_IND LED begins flashing.

Activate the Transmitter4

Press all of the buttons that the transmitter is authorized to use. Any button not pressed will not activate the decoder.

Exit Learn Mode5

Press the LEARN button on the decoder again or let it time out. The new key is now learned and the system is ready for use.