HOW TO INSTALL AND USE Standing Pegs enable your ......Standing Pegs enable your AlvaForm to stand...
Transcript of HOW TO INSTALL AND USE Standing Pegs enable your ......Standing Pegs enable your AlvaForm to stand...
HOW TO INSTALL AND USE THE STANDING PEGS
COMPONENTS IN THE PACKAGE
( v1.0 )
2 side clamps
ACCESSORIES: STANDING PEGS
1 / 3
base bar
wrench
2 standing pegs
Standing Pegs enable your AlvaForm to stand on its feet for dressing tops
There are two Standing Peg sizes, Normal (CS-A) for all sizes from Boy/Girl 5(110cm) and under, and Large (CS-B) for all forms larger than Boy/Girl 5(110cm) .
If your Standing Pegs do not fit, please contact us and we will arrange for the replacement.
Normal - CS-A Large -CS-B
2 / 3
USING STAND PEG MEASUREMENT TO ASSIST INSERTION OF MANNEQUIN
Step 1
Place the base bar at the narrowest point on the AlvaForm stand.
Step 2
Add the side clamps to the base bar.
Step 3
After moving the base bar forward on the AlvaForm stand until it can go no further, begin tightening the screws on the bottom of the side clamps.
Step 4
Place the standing pegs on the movable holed plates and tighten.
Step 5
Find out the stand peg measurementE.g. Half Distance=79mm.
Step 6
Adjust the stand pegs position to the stand peg measurement.
REMINDERThe stand peg measurement is positioned behind the right leg.
REMINDERDifferent mannequins have different stand peg measurements, even if they are same form size.
Step 7
Lock the stand pegs with the wrench provided.
Step 8
Insert the mannequin onto stand pegs.
Half distance = 79mm
3 / 3
CAUTIONDo not hang the form on the hanging bar and insert the legs in the standing pegs at the same time.
CAUTIONDo not only insert one standing peg to support the form.
CAUTIONDo not turn the form when they are on the standing pegs.