How to do BrotherHL 2270DW

Wireless PrinterSetup?

What is Brother HL 2270DW WirelessPrinter Setup?

Connecting Brother HL 2270DW Wireless Printer Setup is fairlysimple. If one has a WLAN access point or router that supportsWPS or AOSS, also known as AirStation One- Touch Secure System,then the Brother machine can be easily connected to the wirelessnetwork.

https://www.brotherprintersupport247.com/blog/brother-hl-2270dw-wireless-printer-setup/

To use Wifi Protected Set Up or WPS, one should confirmthe whether the WLAN has a WPS access.

To configure wireless settings, one should place the Brother machinewithin range of the WPS or the AOSS access point/ router. The rangehowever, might change, depending on the environment.Next, one has to make sure that the wireless cord is plugged in, and thenthe machine should be switched on till it is Ready.Next, one should hold down the WPS or AOSS button on your WLAN accesspointer or router for a few seconds. The time of holding down the buttonwould depend on the WLAN access point.The wireless setup button then has to be located at the back of themachine and pressed down for less than 2 seconds. A pointy object, like aball point pen should be used to press the button.

Note: It is important to remember that the button should not be presseddown for more than 3 seconds, or it will change to the PIN method of theWifi Protected Setup Mode.If all goes well, the machine will search for an WLAN access point/ routerthat will support the Wifi Protected Set Up. All this while, the Toner LEDand the Drum LED would keep blinking.One has to wait till the Ready LED of the machine comes on and indicatedthat the machine is connected. The Ready LED will turn on for 5 minutesindicating that the machine has been successfully connected to Wifi.It is important to note that if the Ready LED is not flashing, then theprinter has not connected to the WLAN router. One should look for anyerrors codes flashed by the machine.

THANK YOU