How 2 Activate Transfer Rules for an Infosource
4
How to activate transfer rules for an Info Source If you get the error below, you have to activate the update rules for the Info Source Start by opening the system with TCODES SCC4 and SE03 Once the system is open, Click on the InfoPackage (IP) which needs the update rules activated. Click on the header tab and copy (ctrl+c) the data target
description
Transfer rules
Transcript of How 2 Activate Transfer Rules for an Infosource
How to activate update rules for an InfoSource
How to activate transfer rules for an Info SourceIf you get the error below, you have to activate the update rules for the Info Source
Start by opening the system with TCODES SCC4 and SE03
Once the system is open, Click on the InfoPackage (IP) which needs the update rules activated. Click on the header tab and copy (ctrl+c) the data target
From Modeling, click on Data Targets and do a search for the data target (ctrl + v)
Click here
Right Mouse click on the data target and select Change
Click on the activate button
Note: The system might ask you for a workbench request. If this happens create a dummy workbench request and proceed.
Once the update rules are activated. Make sure to
1) Close the system
2) Re-run the IP
3) Delete the dummy workbench request using TCODE SE10
