HOME ENERGY IMPROVEMENT PROGRAM PROGRESS ENERGY FLORIDA, INC
2
HOME ENERGY IMPROVEMENT PROGRAM PROGRESS ENERGY FLORIDA, INC. HOME ENERGY IMPROVEMENT HVAC INCENTIVES 04/07 FORM # 921318HEI WHITE-PROGRESS ENERGY YELLOW-CONTRACTOR PINK-CUSTOMER CUSTOMER NAME ACCOUNT NUMBER (COMPLETED BY PE) TA AREA (COMPLETED BY PE) SERVICE ADDRESS PROGRESS ENERGY REPRESENTATIVE CITY STATE ZIP CODE ENERGY MANAGEMENT (COMPLETED BY PE) INPUT DATE (COMPLETED BY PE) PRIMARY PHONE NUMBER DATE INSTALLED AUDIT DATE SQUARE FOOTAGE (CONDITIONED AREA) PERMIT NUMBER (REQUIRED FOR ALL INCENTIVES) CONTRACTOR NAME CONTRACTOR PHONE NUMBER ❑ YES ❑ NO TYPE OF AUDIT (Completed by Progress Energy) ❑ WALK THRU ❑ PHONE ASSISTED ❑ 10% INSPECTION TYPE OF HEATING EQUIPMENT REMOVED ❑ Heat Pump ❑ Straight Cool ❑ Gas/Oil ***NOTE: IF OIL OR GAS HEAT WAS THE PRIOR FUEL, THE CUSTOMER IS NOT ELIGIBLE FOR A HEAT PUMP REBATE CUSTOMER INCENTIVE FOR THE INSTALLATION OF NEW HVAC EQUIPMENT INCENTIVE FORM IS VOID SIX MONTHS AFTER DATE ISSUED Please mail this form and appropriate documentation to Progress Energy at: Progress Energy Florida HVAC Incentive 3300 Exchange Place, NP2A Lake Mary, FL 32746 OR Progress Energy Florida HVAC Incentive 4121 St. Lawrence Drive New Port Richey, FL 34653 FIRST UNIT INSTALLED SECOND UNIT INSTALLED SEER HSPF SEER ≥ 14 AND HSPF ≥ 7.8 SEER ≥ 15 AND HSPF ≥ 8.0 ❑ $100 ❑ $150 ❑ $250 ❑ $350 SEER HSPF SEER ≥ 14 AND HSPF ≥ 7.8 SEER ≥ 15 AND HSPF ≥ 8.0 ❑ $100 ❑ $150 ❑ $250 ❑ $350 MANUFACTURER NAME OUTDOOR MODEL NUMBER INDOOR MODEL NUMBER CAPACITY (BTUH) SEER & HSPF EFFICIENCY HEAT PUMP TO HEAT PUMP INCENTIVE RESISTANCE HEAT TO HEAT PUMP INCENTIVE EVAPORATOR COIL MODEL NUMBER EFFICIENCY NON-ELECTRIC TO NON-ELECTRIC HEATING INCENTIVE SEER ≥ 14 SEER ≥ 14 ❑ $50 ❑ $50 CONTRACTOR INCENTIVES APPLY ONLY WHEN ANEW HVAC SYSTEM IS BEING INSTALLED THAT MEETS EFFICIENCY REQUIREMENTS Permit number and all equipment information located above is required. Efficiency rating of ≥ 14 SEER is required with a matching evaporator coil WHEN APPLYING FOR CUSTOMER AND CONTRACTOR INCENTIVES: A COPY OF ARI FORM AND CUSTOMER INVOICE MUST ACCOMPANY THIS INCENTIVE FORM To qualify for an incentive follow the requirements for the appropriate program presented in the Heat Pump Incentive Checklist or the Electric A/C with Non-Electric Heat checklist. ❑ INCENTIVE: $25 ❑ INCENTIVE: $10 ❑ INCENTIVE: $50 ❑ INCENTIVE: $75 ❑ INCENTIVE: $50 ❑ PASS ❑ FAIL ❑ PASS ❑ FAIL ❑ PASS ❑ FAIL Progress Energy Inspection Section Mastic is used Equipment installed matches ARI document Equipment installed matches ARI document PE REPRESENTATIVE NAME DATE Submittal and completion of Heat Pump incentive paperwork Submittal and completion Non-Electric Heating incentive paperwork SUPPLY & RETURN PLENUM SEAL Only electric heating systems are allowed for incentive participation Only mastic and fiber cloth with embedded fiber (mixed) may be used to seal the supply and return plenum system. Mastic must meet UL 181 specifications for the material that the mastic is being applied to. PROPER SIZING OF HIGH EFFICIENCY HVAC All heating fuels allowed for incentive participation HVAC COMMISSIONING All heating fuels allowed, attach sizing software analysis, unit’s tonnage must be within 1/2 ton of size from that analysis MANUFACTURER OF SIZING SOFTWARE: SIZING SOFTWARE RECOMMENDATION TOTAL BTUH: BTUH OF INSTALLED EQUIPMENT: MANUFACTURER OF HVAC COMMISSIONING SOFTWARE: Copy of analysis printout from software showing: BTU rating before and after improvements are made System performs at + or - 15% of manufacturer’s specified BTU’s after improvements The contractor and customer must follow Progress Energy’s requirements as stated on the appropriate checklist to receive incentive. The contractor certifies that the air flow meets the manufacturer’s requirements and specifications for the system installed. Also, that the refrigerant charge and type are according to manufacturer’s specifications and recommendations for the unit installed. I certify that the unit is tested and is leak free. I further certify that the hard start kit has been installed on any scroll compressor 36.001 BTU’s or larger. CONTRACTOR SIGNATURE DATE
Transcript of HOME ENERGY IMPROVEMENT PROGRAM PROGRESS ENERGY FLORIDA, INC
HOME ENERGY IMPROVEMENT PROGRAMPROGRESS ENERGY FLORIDA, INC.
HOME ENERGY IMPROVEMENT HVAC INCENTIVES
04/07 FORM # 921318HEIWHITE-PROGRESS ENERGY YELLOW-CONTRACTOR PINK-CUSTOMER
CUSTOMER NAME ACCOUNT NUMBER (COMPLETED BY PE) TA AREA (COMPLETED BY PE)
SERVICE ADDRESS PROGRESS ENERGY REPRESENTATIVE
CITY STATE ZIP CODE ENERGY MANAGEMENT (COMPLETED BY PE) INPUT DATE (COMPLETED BY PE)
PRIMARY PHONE NUMBER DATE INSTALLED AUDIT DATE
SQUARE FOOTAGE (CONDITIONED AREA) PERMIT NUMBER (REQUIRED FOR ALL INCENTIVES)
CONTRACTOR NAME CONTRACTOR PHONE NUMBER
❑ YES ❑ NO
TYPE OF AUDIT(Completed by Progress Energy)
❑ WALK THRU
❑ PHONE ASSISTED
❑ 10% INSPECTION
TYPE OF HEATINGEQUIPMENTREMOVED ❑ Heat Pump ❑ Straight Cool ❑ Gas/Oil
***NOTE: IF OIL OR GAS HEAT WAS THE PRIOR FUEL, THE CUSTOMERIS NOT ELIGIBLE FOR A HEAT PUMP REBATE
CUSTOMER INCENTIVE FOR THE INSTALLATION OF NEW HVAC EQUIPMENT
INCENTIVE FORM IS VOID SIX MONTHSAFTER DATE ISSUED
Please mail this form and appropriatedocumentation to Progress Energy at:
Progress Energy FloridaHVAC Incentive
3300 Exchange Place, NP2ALake Mary, FL 32746
OR
Progress Energy FloridaHVAC Incentive
4121 St. Lawrence DriveNew Port Richey, FL 34653
FIRST UNIT INSTALLED SECOND UNIT INSTALLED
SEER HSPF
SEER ≥ 14 AND HSPF ≥ 7.8 SEER ≥ 15 AND HSPF ≥ 8.0
❑ $100 ❑ $150
❑ $250 ❑ $350
SEER HSPF
SEER ≥ 14 AND HSPF ≥ 7.8 SEER ≥ 15 AND HSPF ≥ 8.0
❑ $100 ❑ $150
❑ $250 ❑ $350
MANUFACTURERNAME
OUTDOOR MODELNUMBER
INDOOR MODELNUMBER
CAPACITY (BTUH)
SEER & HSPF
EFFICIENCY
HEAT PUMP TOHEAT PUMPINCENTIVE
RESISTANCE HEATTO HEAT PUMPINCENTIVE
EVAPORATOR COILMODEL NUMBER
EFFICIENCY
NON-ELECTRIC TO NON-ELECTRICHEATING INCENTIVE
SEER ≥ 14 SEER ≥ 14
❑ $50❑ $50
CONTRACTOR INCENTIVES APPLY ONLY WHEN A NEW HVAC SYSTEM IS BEING INSTALLED THAT MEETS EFFICIENCY REQUIREMENTS
Permit number and all equipment information located above is required. Efficiency rating of ≥ 14 SEER is required with a matching evaporator coil
WHEN APPLYING FOR CUSTOMER AND CONTRACTOR INCENTIVES: A COPY OF ARI FORM AND CUSTOMER INVOICE MUST ACCOMPANY THIS INCENTIVE FORM
To qualify for an incentive follow the requirements for the appropriate program presented in the Heat Pump Incentive Checklist or the Electric A/C with Non-Electric Heat checklist.
❑ INCENTIVE: $25
❑ INCENTIVE: $10
❑ INCENTIVE: $50
❑ INCENTIVE: $75
❑ INCENTIVE: $50
❑ PASS
❑ FAIL
❑ PASS
❑ FAIL
❑ PASS
❑ FAIL
Progress EnergyInspection Section
Mastic isused
Equipmentinstalledmatches
ARIdocument
Equipmentinstalledmatches
ARIdocument
PE REPRESENTATIVE NAME DATE
Submittal and completion of Heat Pump incentive paperwork
Submittal and completion Non-Electric Heating incentive paperwork
SUPPLY & RETURN PLENUM SEAL Only electric heating systems are allowed for incentive participation
Only mastic and fiber cloth with embedded fiber (mixed) may be used to seal the supply and return plenum system.Mastic must meet UL 181 specifications for the material that the mastic is being applied to.
PROPER SIZING OF HIGH EFFICIENCY HVAC
All heating fuels allowed for incentive participation HVAC COMMISSIONING
All heating fuels allowed, attach sizing software analysis,unit’s tonnage must be within 1/2 ton of size from that analysis
MANUFACTURER OF SIZING SOFTWARE:
SIZING SOFTWARE RECOMMENDATION TOTAL BTUH: BTUH OF INSTALLED EQUIPMENT:
MANUFACTURER OF HVAC COMMISSIONING SOFTWARE:
Copy of analysis printout from software showing:
BTU rating before and after improvements are madeSystem performs at + or - 15% of manufacturer’s
specified BTU’s after improvements
The contractor and customer must follow Progress Energy’s requirements as stated on the appropriate checklist to receive incentive. The contractor certifies that the air flow meets themanufacturer’s requirements and specifications for the system installed. Also, that the refrigerant charge and type are according to manufacturer’s specifications and recommendations forthe unit installed. I certify that the unit is tested and is leak free. I further certify that the hard start kit has been installed on any scroll compressor 36.001 BTU’s or larger.
CONTRACTOR SIGNATURE DATE
HOME ENERGY IMPROVEMENT PROGRAMPROGRESS ENERGY FLORIDA, INC.
HOME ENERGY IMPROVEMENT HVAC INCENTIVESCUSTOMER NAME ACCOUNT NUMBER (COMPLETED BY PE) TA AREA (COMPLETED BY PE)
SERVICE ADDRESS PROGRESS ENERGY REPRESENTATIVE
CITY STATE ZIP CODE ENERGY MANAGEMENT (COMPLETED BY PE) INPUT DATE (COMPLETED BY PE)
PRIMARY PHONE NUMBER DATE INSTALLED AUDIT DATE
SQUARE FOOTAGE (CONDITIONED AREA) PERMIT NUMBER (REQUIRED FOR ALL INCENTIVES)
CONTRACTOR NAME CONTRACTOR PHONE NUMBER
❑ YES ❑ NO
TYPE OF AUDIT(Completed by Progress Energy)
❑ WALK THRU
❑ PHONE ASSISTED
❑ 10% INSPECTION
TYPE OF HEATINGEQUIPMENTREMOVED ❑ Heat Pump ❑ Straight Cool ❑ Gas/Oil
***NOTE: IF OIL OR GAS HEAT WAS THE PRIOR FUEL, THE CUSTOMERIS NOT ELIGIBLE FOR A HEAT PUMP REBATE
CUSTOMER INCENTIVE FOR THE INSTALLATION OF NEW HVAC EQUIPMENT
INCENTIVE FORM IS VOID SIX MONTHSAFTER DATE ISSUED
Please mail this form and appropriatedocumentation to Progress Energy at:
Progress Energy FloridaHVAC Incentive
3300 Exchange Place, NP2ALake Mary, FL 32746
OR
Progress Energy FloridaHVAC Incentive
4121 St. Lawrence DriveNew Port Richey, FL 34653
FIRST UNIT INSTALLED SECOND UNIT INSTALLED
SEER HSPF
SEER ≥ 14 AND HSPF ≥ 7.8 SEER ≥ 15 AND HSPF ≥ 8.0
❑ $100 ❑ $150
❑ $250 ❑ $350
SEER HSPF
SEER ≥ 14 AND HSPF ≥ 7.8 SEER ≥ 15 AND HSPF ≥ 8.0
❑ $100 ❑ $150
❑ $250 ❑ $350
MANUFACTURERNAME
OUTDOOR MODELNUMBER
INDOOR MODELNUMBER
CAPACITY (BTUH)
SEER & HSPF
EFFICIENCY
HEAT PUMP TOHEAT PUMPINCENTIVE
RESISTANCE HEATTO HEAT PUMPINCENTIVE
EVAPORATOR COILMODEL NUMBER
EFFICIENCY
NON-ELECTRIC TO NON-ELECTRICHEATING INCENTIVE
SEER ≥ 14 SEER ≥ 14
❑ $50❑ $50
The contractor and customer must follow Progress Energy’s requirements as stated on the appropriate checklist to receive incentive. The contractor certifies that the air flow meets themanufacturer’s requirements and specifications for the system installed. Also, that the refrigerant charge and type are according to manufacturer’s specifications and recommendations forthe unit installed. I certify that the unit is tested and is leak free. I further certify that the hard start kit has been installed on any scroll compressor 36.001 BTU’s or larger.
CONTRACTOR SIGNATURE DATE
04/07 FORM # 921318HEIWHITE-PROGRESS ENERGY YELLOW-CONTRACTOR PINK-CUSTOMER
