Hofmann

Alignment Adjustment Features

TrainingA-ARM Adjustment

Why would the Technician want to make an adjustment?

Low Caster on right side and High Camber on right side resulting in a Pull condition to the Right.

This Screen is indicating to move the front of the Upper A-Arm in, and the rear of the Upper

A-Arm in

Select the Jack icon to Toggle from Elevated or Turntable adjustment

If the adjustments are on the Lower Control Arm, Click on the icon to Toggle to

the Lower A Arm

It would now be necessary to move the Lower A-Arm out at the front and out at the

rear

As you move the A-Arm, in the indicated direction, the scale will move towards the

center.

This screen shows the left side adjustment

Because the left side is near desired, the Technician may skip past the left side adjust screen by clicking on the green

icon

Caster and Camber adjustments will normally change the Toe setting. It will

now be necessary to adjust the Toe

A-Arm adjust mode will use the preferred specification as the desired end result.

If a setting other than preferred is desired, edit the specifications and make the

desired setting the preferred

Caster and Camber set to factory preferred

Preferred Caster and Camber altered to help offset road crown pull

WwwwwWWW