HO Structure KitALLIED RAIL REBUILDERS

933-3016

© 2012 Wm. K. Walthers, Inc., Milwaukee, WI 53218 waltherscornerstone.com I-933-3016S

Thanks for purchasing this Cornerstone Series® kit. All parts are molded in styrene, so use compatible paints and glues. Please take a few minutes to read the directions and study the drawings.

Many rebuilders started operations in the late 70's, when large railroads began trading in older diesels on new power. These locomotives were often in operating condition, and since so many were available, prices plummeted. The glut of used equipment made it possible to buy and rebuild locomotives for a fraction of the cost of new motive power. Rebuilding services acquired the locomotives, overhauled them and sold them to short lines, as well as some larger roads. Some created rebuilt locomotive fleets which could be leased by a line which found itself short on motive power.

To carry out these various operations, a well-equipped shop is a must. Older industrial buildings are often used, as they have few interior obstructions, high ceilings to clear oversize equipment and large windows for natural interior lighting. Many were also designed so freight cars could be spotted inside for loading and unloading. The original overhead doors and interior trackage simplified converting the building to a shop.

Allied Rail Rebuilders can be used in many different ways. As a rebuilding shop, you can showcase your collection of cars and locos from various railroads. The EMD "567" prime mover included in the kit can be used as an interior detail, or loaded aboard a GSC Flat Car for delivery to an off-line customer.

For additional figures, vehicle and accessories to set the scene see your dealer, check out the latest Walthers HO Scale Model Railroad Reference book or visit our Web site at waltherscornerstone.com for more ideas.

25

13 x8

4

27

26

26

17

16

16

5

23S

21

22

2

14

13

24 2525

15

1325

14

24

2818

19

14

2524

1424

13

2014

3

24

1424

13

2818

19

15

5

4

36 x3 5

4

2

1

9

10

7

12 x2

11 x28

41 x4 12 11

1211

12 x2

11 x2

7

8

3939

31 x229

32

30

40

33

40

3738

35

36 34 38 37

DECALING1. After cutting out the decal, dip in water for 10 seconds, remove and let stand for 1 minute. Slide decal onto surface, position and then blot off any excess water.2. Lightly brush Micro Sol® on top. This will soften the decal allowing it to conform to irregular surfaces. DO NOT TOUCH DECAL while wet!3. When the decal is thoroughly dry, check for any trapped air bubbles. Prick them with the point of a small pin or hobby knife blade and apply more Micro Sol®.