High Yield Impact Explosive

3
HOW TO MAKE A PRANK BOMB

description

this is bad book

Transcript of High Yield Impact Explosive

  • HOW TO MAKE A PRANK BOMB

  • The proceedure is very simple, and is as follows:

    Ingredients,

    1. 200ml of pure propanoneCH3COCH3 (dimethyl ketone)

    2. 200ml of hydrogen peroxide, H2O2 (the stronger the better)

    3. 10ml of hydrochloric acid, HCl (38% muratic acid)

    Proceedure,

    A. Combine the propanone and the hydrogen peroxide in a 500ml or

    larger

    beaker

    or other heat resistant glass vessel. Gently and without flame, warm the

    mixture

    to 50 deg. centigrade. While gently agitating with a glass rod, begin

    adding the

    acid, drop by drop.

    acid, one drop at a time until a white precipitate begins to form, or all

    the

    acid has been added. The stronger the H2O2, the less HCl will be

    required.

    If

    no precipitate begins to appear, when all the acid is added, allow to

    stand

    for

    up to 3 days, uncovered in a warm place. At the end of this time, there

    will be

    a white crystaline precipitate on the bottom and top of the

    vessel. Filter

    through coffee filters, disposing of the liquid in an enviromentaly

    conscious

    manner. Wash the precipitate with 2 to 4 quarts of distilled water. The

    water

    used must contain no lime or chlorine. Air dry the crystals, on the

    filter

    paper

    for 24 -48 hours. If the humidity is high, further drying over a warm

    iron

    skillet of dry sand may be necessary. When the crystals no longer will

    stick

    together when pinched, place them in an airtight bottle.

    Use.

    These crystals detonate upon impact at an extremely fast rate. They burn

    like

    flash powder, only much faster. You can make exploding bullets with them

    by

    gently filling hollow point bullets with the crystals, and capping with a

    bit of

    epoxy.. DO NOT ATTEMPT TO GRIND INTO POWDER, IT WILL EXPLODE, VERY

    POWERFULLY.

    To test your product, use a hammer on a pile the size of a pin head on a

    block of

    steel. If excessive force is required, it may not be dry enough. Use

    caution in

    making and handling this item. Store only in a cool dry place. Must be

    kept

    completely dry, away from sparks, heat, and static electricity. Make and

  • use at

    your own risk.