High Quality Enclosed Multi Phase Cleaning plant · Layton High Quality Enclosed Multi Phase...

Home > Cleaning & Degreasing MachineryAqueous Ultrasonic Cleaning & Washing >

Layton High Quality Enclosed Multi Phase Cleaning plant

Stock Code: DX1269SManufacturer: LaytonModel: ISLA SpA IW20Year of Manufacture: 2007Serial: MAC102667New or Used: Used (Second Hand)Work Envelope (WxDxH mm): 320 x 480 x 200Process Stages: Multiple + Steam clean & vacuum dryingOther Info: Exceptional high standard of cleaningExternal Dimensions (WxDxH): 1100 x 1500 x 2250

Layton Bluestream Aqueous Metal Degreasing plant

Parts clean in a single chamber using a combination of immersion, spray and ultrasonic agitation + Vacuum and hotair drying options.

Parts are loaded via front door, once door is closed a seal is formed and the holding tank fills with water.

Once the wash cycle is complete water drain's from the chamber and then the wetted parts are dried using vacuumprocess.

The Marketplace for Surface Technology.New and Used Process Equipment & Machinery.

Riley Industries LtdA subsidiary of Barry Riley & Sons Ltd. Director: M P A Riley, Secretary: D Hemming

Registered in England no. 1965748

/7

https://www.rileysurfaceworld.co.uk

https://www.rileysurfaceworld.co.uk/cleaning_and_degreasing.asp

https://www.rileysurfaceworld.co.uk/cleaning-ultrasonic-aqueous.asp



Complete with inbuilt fully programmable touch screen computer

Sequence of treatment

Filling of the pump - To prime the pump water is circulated from the tank of the machine and back to the tank of themachine. In the meantime the tank reaches the requested temperature of 80°c

Rinsing pieces - Through the circulation pump water is taken in form tank 1 and pumped through the filter and thein-line heater by the spray injectors into the treatment chamber. A part of the dirt of the pieces is removed. Thisprocedure goes on until reaching the set level in the chamber.

Pre-washing - The removed dirt is now filtered and additional dirt is dissolved. This is done by circulating the waterby the pump from the chamber, through the filters and the in-line heater back to the chamber.

Emptying the treatment chamber - After the end of the pre-cleaning cycle, the water is discharged form the machine.

High level in chamber - Water is pumped by the circulation pump from tank 2 through the spray injectors in to thetreatment chamber passing by the filter and the in-line heater. This procedure carries on until reaching the set levelin the chamber.

Washing cycle - The removed dirt is filtered and additional dirt is dissolved. This is done by circulating the water bythe pump from the chamber, through the filters and the in-line heated back to the chamber.

Emptying the treatment chamber- After the washing cycle the water is discharged from the treatment chamberthrough the filter and pump then pumped to tank 1 until the maximum level is reached. the additional water isdischarged from the machine.

Degreasing with vapours - For degreasing the pieces steam vapours at a temperature of 140°c are introduced to thetreatment chamber directly from the boiler

Emptying the piping - Before staring the drying cycle the piping is emptied from the residual water, furthermore thelevel in tank 2 is restored automatically

Vacuum drying - Through the vacuum pump, air and steam vapours are sucked from the treatment chamber untilreaching an absolute pressure of about 80 mbar in the chamber. After reaching the set pressure of 80 mbar thevacuum is broken to atmospheric pressure.

Drying at atmospheric pressure - By means of the turbine air is circulated through the heater and conveyed to thetreatment chamber. Here the air yields part of its heat and the water evaporates form the treated pieces. The air nowsaturated with steam vapours then passes through a cooler where the water may condense. These heating andcooling cycles of air are repeated until the load is completely dry.

Programmable computer

General features




/7






Display7.5" Graphic DisplayResolution = 640 x 480 dotsFluorescent retro illuminationResistive touch screen panel

1/0Main board inside the IL3 Touch Screen computer17 digital single point set relay outputs with potential free and normally opened contact (max 24 Volts, 5 A)32 digital outputs in direct current 24 Vdcanalogue outputs 0-10Vanalogue outputs 0-10V for inverter control32 opto isolated digital inputs in 24 Vdcanalogue inputs for PTC o PT1002 analogue inputs 0-10V2 analogue inputs for drying control

HardwareIL3 Touch Screen ComputerCPU board with RS 232 interface for PC communication and RS 485 interface for network communication betweenother IL3 TS connected to a PCResistive touch screen panel RS485 connection on backside RS232 connection onfront sideLamp protection mode by switching off display after 10 minutes of non-use

SoftwareMemory capacity for 50 programs 60 steps for each program10 functions for each stepSimplified programming through the use of graphic symbols Messages are stored with date for statistics and controloperations Possibility to assign program and step description individuallyWide possibilities to communicate with PC for download and upload of all machine data Possibility to monitor themachine functions on-line by PC6 languages for selection by customerPossibility to assign to every symbol one ore more electric commands (outputs) Possibility to program specialfunctions through the PLC languageFlexible alarms management, permitting to modify messages or adding new ones determining the alarm levelIt is possible to program the automatic starting of some functions

Model Treatment chamber W20Diameter

mm




/7





Layton High Quality Enclosed Multi Phase Cleaning plant450

Depth

mm

550

Volume

I

96

Basket holder

Width

mm

330

Depth

mm

490

Height

210

Max eatload

kg

50

Loading door size Width




/7





Layton High Quality Enclosed Multi Phase Cleaning plantmm

450

Height

mm

320

Rotation speed basket holder Min.

min 1

2

Max.

min 1

12

Effective volume Tank 1

I

70

Tank 2

I

70

Water load

Max.

I

140




/7






Max.

k

140

Machine dimensions Width

mm

1070

Depth

mm

1415

Height

mm

2120

Weights Empty weight

kg

650

Installation connections Compressed air Connection

1/4

Pressure

bar

7

Flow rate

1/min




/7






50

Cooling water Connection

1/2

Pressure

Max. temperature

bar

3-5

25

Flow rate, min

m3/h0.5

View Layton High Quality Enclosed Multi Phase Cleaning plant on our web site athttps://www.rileysurfaceworld.co.uk/machines/28962.htm

PHOTOGRAPHS TAKEN PRIOR TO REFURBISHMENT.




/7




https://www.rileysurfaceworld.co.uk/machines/28962.htm

High Quality Enclosed Multi Phase Cleaning plant · Layton High Quality Enclosed Multi Phase...

Documents

Transcript of High Quality Enclosed Multi Phase Cleaning plant · Layton High Quality Enclosed Multi Phase...