Hicom150exam
-
Upload
nasser-annasser -
Category
Documents
-
view
215 -
download
0
Transcript of Hicom150exam
-
7/29/2019 Hicom150exam
1/2
Directorate of Communications and ElectronicsExchanges Branch
Final Result: ( of 100% )
Position:Hicom 150 CourseQuizzes: ( of 10% )
Exam : ( of 70% ) Final ExamDate : Thursday 21 Feb 2008Practical Implementation: ( of 20% )
Unit: ( )Name: ( )
Number: ( )
Q1: Choose The One Correct Answer A, B, C, or D : The voice frequency range of Human being is:A: 300KHz to 3400KHz B: 300Hz to 3400KHz
C: 0.300KHz to 3.400KHz D: All of the above
In the telephone PCM system the sampling rate would be:A: 8 Kbytes/sec B: 8000 Bit/sec
C: 8 106 Hz D: None of above
What the sampling rate would be if the time intervals was 62.5 sec:A: Higher than 8 10
3 Hz B: Less than 8 103 Hz
C: 8 103 Hz D: None of the above
The mother board supports:A: Twelve Built in Stations B: 4 SLU
C: 8 SLA D: All of the above
Hicom150E OfficeCom is considered:A: Mechanical exchange. B: SPC exchange.
C: Electromechnical exchange. D: None of the above.
OptiSet E Memory is connected to the exchange by:A: Fiber Cable. B: Coaxial Cable.
C: Two Couples of Copper Wire. D: None of the above.
The output of the power supply \ charger is:A: -48VDC. B: 75VAC.
C: 54VDC. D: none of the above.
The 5.1 VDC which comes out of the power supply is to feed the:A: CMOS IC's B: RingerC: Extension circuits D: All of the above
To restart the exchange manually, you have to press on the restart switch and hold up to:A: Eight seconds. B: Less than eight seconds.
C: More than eight seconds. D: Non of the above.
The default code of the attendant is:A: 9. B: 0.
C: 80. D: None of the above.
-
7/29/2019 Hicom150exam
2/2
Q2: Please Mark ( ) Before The Correct Sentence, And ( X ) Before The Wrong Sentence.1. ( ) We can prevent the subscribers in the same exchange form having the external lines using
Call Barring Menu program
2. ( ) The trunk line code cannot be changed.
3. ( ) The mother board of the hicom150 supports ISDN E1/PRI.
4. ( ) Hicom150E is considered one of Ricoh's industries.
5. ( ) 75 VACwith 25Hz is the needed voltage and frequency to make the Optiset-E-memory rings
6. ( ) The first step in programming should be initializing the exchange by the international or
Sweden initialization.
Q3: Complete the following Sentences:
1. PABX stands for
2. 8 SLU Board Supports
3. 16 SLA Board Supports.
4. The mother board supports and
5. 8 TLA Supports
6. UPS stands for
7. Lithiumbattery used for..
Q4: Write down the color of the twisted pairs below, using the international color code arrangements.
Pair No. Colors Pair No. Colors
1. & 9. &
18. & 26. &
3. & 11. &
20. & 28. &
5. & 13. &
Q5: Name the following components and what is the right numbering of the slots: