HEXAPOD ROBOTMINI PROJECT

B-TECH ELECTRONICS AND COMMUNICATION ENGINEERING

SIXTH SEMESTER

ASWATHY.KRANJITH.R

SREELAKSHMI.MSREEYENAN.E.K

GUIDEMs.Sreebala.P

Department of Electronics and Communication EngineeringSreepathy Institute of Management and Technology

Vavanoor, Koottanad (via), Palakkad, 679583

pizzazz666@gmail.comhttp://pizzazz666.blogspot.in/

1

OBJECTIVE INTRODUCTION BLOCK DIAGRAM WORKING COMPONENTS REQUIRED CONCLUSION REFERENCES

2

Main objective of this project is to create a base hexapod platform which can traverse on rough terrain

It needs feedback and positive reaction to acquire smoother walk.

The hexapod robot is to be controlled remotely.

3

Hexapod Robot.• This robot has six legs, and each leg has

three servo motors.• This robot is constructed and is designed to

be controlled remotely with the software or with joystick of play station.

• User can design this robot to perceive as well as avoid the obstacles in front.

• The PCB is the main board consisted of ATmega128.

5

6

The system for controlling the robot relies on the interaction of three main elements. ooperatorophysical robotosoftwareA PC pairs with the BlueSmirf Receives the Commands and sends them to the master processor. The processor contains all the necessarily algorithms such as Direct Servo control, After processing the input signals from BlueSmirf, It sends them to Mini Polulu “the Sevo Driving Circuit” using TX/RX serial Communication protocol.

7

Relation between operation angle of servo motor and signal pulse

Controller : AVR(A TMEGA 128) 8 bit controller.

Memory type : Control by using EEPROM in CPU

Servo Motors(RBM-606MG) Blue smirf /RF wireless module : 2ea Zigbee wireless moduel(ZBS-100) :2ea

8

The overall conclusion of the project is that a control system that can successfully control the robot can be designed, and the system will able to generate satisfactory gaits on flat ground.

9

THANK YOU

10