PRODUCT DESIGN, DEVELOPMENT AND VIABILITY ANALYSIS MOTORCYCLE HELMET LIGHT
Helmet Light User Instructions
-
Upload
evangelina-zaro -
Category
Documents
-
view
30 -
download
1
description
Transcript of Helmet Light User Instructions
Helmet Light User Instructions
Rotate Tail cap counter clock wise to open battery compartment
IR / IFF lever(only functional light
In this mode)
Two functional buttons, One functional lever
Insert AA Battery Tip end first
Primary –White Light Secondary –
Red or Blue Light (one or the other, not both available in each light)
Mounting the Helmet Bracket Bracket can be mounted in any location along the rim of the helmet for operator
comfort and ease of use.
Step 1 – loosen Screw until flush with J Bracket.
Step 2 –Install bracket on the rim of your helmet at your desired location
Step 3 – When J hook bracket and bottom of mount are flush with the rim of your Helmet, Then tighten screw.
Battery Compartment and Installation
Helmet Light User Instructions
White Light – Top Button (left side mounted)
IR Light –Lower Light
Red or Blue Light–Top Light
White Light -- Center Light
Light location Right side Mounted
Light location Left side Mounted
White Light – Bottom Button (right side mounted)
Red or Blue Light – Top button (right side mounted)
Red Or Blue Light –Lower Light
IR Light–Top Light
White Light -- Center Light
Three modes of operations Primary and Secondary LightPress 1X – lowPress 2X -- MediumPress 3X -- High
(if light has been on for more than three seconds, next press will extinguish the light)
Red or Blue Light – Bottom Button (left side mounted)
Helmet Light User Instructions
IR Light—Move lever up to engage
IR light (all other lights are disabled in this mode)
To Engage IR/IFF Left side mountedTo Engage IR/IFF Right side mounted
IFF Mode—Move lever down to engage the IFF mode (all other lights
are disabled in this mode)
IR Light—Move lever down to engage IR light (all other lights are
disabled in this mode)
IFF Mode—Move lever up to engage IFF
Mode (all other lights are disabled in this mode)
To Engage the lock out feature
Turn the tail cap ¼ turn (light is still water proof)
Tab should be aligned centered with Hard Case Logo
IFF Light IFF LightIR LightConstant OnOne level of brightness
IFF LightNeed Flash input
Helmet Light User Instructions
Step 2—slide light upwards to
remove light.
Rotating your Helmet Light
Step 1 —Depress the T-Bar to
disengage locking bracket
Step 1 —While mounted gently pull
light away from helmet
Step 2 —Rotate into your desired
position
Removing your Helmet Light from your Helmet
Mounting bracket has 20 lockable positions within the 360 degree rotation!
Step 1 —Depress the T-Bar to
disengage locking bracket
Removing your Helmet Light from your OTV/FLC
Step 2 —Slide light rear wards to
remove light.
Recommended Hand Position To avoid accidental discharge (AD) of colored lights. Finger position should be end to end.