Helmet Light User Instructions

Rotate Tail cap counter clock wise to open battery compartment

IR / IFF lever(only functional light

In this mode)

Two functional buttons, One functional lever

Insert AA Battery Tip end first

Primary –White Light Secondary –

Red or Blue Light (one or the other, not both available in each light)

Mounting the Helmet Bracket Bracket can be mounted in any location along the rim of the helmet for operator

comfort and ease of use.

Step 1 – loosen Screw until flush with J Bracket.

Step 2 –Install bracket on the rim of your helmet at your desired location

Step 3 – When J hook bracket and bottom of mount are flush with the rim of your Helmet, Then tighten screw.

Battery Compartment and Installation

Helmet Light User Instructions

White Light – Top Button (left side mounted)

IR Light –Lower Light

Red or Blue Light–Top Light

White Light -- Center Light

Light location Right side Mounted

Light location Left side Mounted

White Light – Bottom Button (right side mounted)

Red or Blue Light – Top button (right side mounted)

Red Or Blue Light –Lower Light

IR Light–Top Light

White Light -- Center Light

Three modes of operations Primary and Secondary LightPress 1X – lowPress 2X -- MediumPress 3X -- High

(if light has been on for more than three seconds, next press will extinguish the light)

Red or Blue Light – Bottom Button (left side mounted)

Helmet Light User Instructions

IR Light—Move lever up to engage

IR light (all other lights are disabled in this mode)

To Engage IR/IFF Left side mountedTo Engage IR/IFF Right side mounted

IFF Mode—Move lever down to engage the IFF mode (all other lights

are disabled in this mode)

IR Light—Move lever down to engage IR light (all other lights are

disabled in this mode)

IFF Mode—Move lever up to engage IFF

Mode (all other lights are disabled in this mode)

To Engage the lock out feature

Turn the tail cap ¼ turn (light is still water proof)

Tab should be aligned centered with Hard Case Logo

IFF Light IFF LightIR LightConstant OnOne level of brightness

IFF LightNeed Flash input

Helmet Light User Instructions

Step 2—slide light upwards to

remove light.

Rotating your Helmet Light

Step 1 —Depress the T-Bar to

disengage locking bracket

Step 1 —While mounted gently pull

light away from helmet

Step 2 —Rotate into your desired

position

Removing your Helmet Light from your Helmet

Mounting bracket has 20 lockable positions within the 360 degree rotation!

Step 1 —Depress the T-Bar to

disengage locking bracket

Removing your Helmet Light from your OTV/FLC

Step 2 —Slide light rear wards to

remove light.

Recommended Hand Position To avoid accidental discharge (AD) of colored lights. Finger position should be end to end.