AWS D1.4/D1.4M:2011

56

Sample Welding Procedure Specification (WPS) FormWelding Procedure Specification (WPS) No. ______________

Contractor ____________________________________Authorized by _________________________________ Revision No. ___________________________________Supporting PQR Identification_____________________ Test Date _____________________________________

WELDING PROCESS: FCAW-S FCAW-G GMAW SMAW

WELD TYPE: Groove Fillet

JOINT TYPE: Direct Butt Indirect Butt T-JointJoint(s) Qualified (see Table 6.3) _____________________________________________________________________Position ________________________ Groove Type____________________________________________________Root Opening ___________________ Root Face ______________________ Groove Angle _________________Backing: Yes No Backing Type ___________________________________________________Backgouging: Yes No Backgouging Method _____________________________________________

TECHNIQUE: Stringers Weave

ELECTRICAL CHARACTERISTICSCurrent: AC DCEP DCENTransfer Mode (GMAW): Short-circuiting Globular SprayBASE METAL

Material Specification________________________________ Grade _______________________Welded to: Material Specification________________________________ Grade _______________________Maximum Carbon Equivalent _______ Bar size ________________________ Plate Thickness _______________Coated Bar: Yes No Type of Coating _________________________________________________

FILLER METALAWS Specification______________________________ AWS Classification ______________________________Describe filler metal (if not covered by AWS specifications) _________________________________________________SHIELDINGGas: Single Mixture Composition_____________________ Flow rate_____________________

PREHEAT/INTERPASSPreheat/Interpass Temperature (Min) _______________ Interpass Temperature (Max) ______________________

WELDING PARAMETERS

Manufacturer or Contractor __________________________________________________________________________

Authorized by _______________________________________________________ Date ___________________

Form A-2

Pass Number(s)

Electrode Diameter

Current TravelSpeed

ipm [mm/min.]JointDetailType

AmperageRange

VoltsRange

ElectricalStickout

Welding Procedure Specification WPS No: Contractor: Authorized by: Revision No: Supporting PQR Identification: Test Date: FCAWS: FCAWG: GMAW: SMAW: Groove: Fillet: Direct Butt: Indirect Butt: TJoint: Joints Qualified see Table 63: Position: Groove Type: Root Opening: Root Face: Groove Angle: Backing Type: TECHNIQUE:

undefined:

Backgouging Method: Weave: AC: DCEP: DCEN: Shortcircuiting: Globular: Spray: Material Specification: Grade: Material Specification_2: Grade_2: Maximum Carbon Equivalent: Bar size: Plate Thickness: Coated Bar:

Type of Coating: AWS Specification: AWS Classification: Describe filler metal if not covered by AWS specifications: Single: Mixture: Composition: Flow rate: PreheatInterpass Temperature Min: Interpass Temperature Max: Pass NumbersRow1: Electrode DiameterRow1: TypeRow1: Amperage RangeRow1: Volts RangeRow1: Electrical StickoutRow1: Travel Speed ipm mmminRow1: Pass NumbersRow2: Electrode DiameterRow2: TypeRow2: Amperage RangeRow2: Volts RangeRow2: Electrical StickoutRow2: Travel Speed ipm mmminRow2: Pass NumbersRow3: Electrode DiameterRow3: TypeRow3: Amperage RangeRow3: Volts RangeRow3: Electrical StickoutRow3: Travel Speed ipm mmminRow3: Pass NumbersRow4: Electrode DiameterRow4: TypeRow4: Amperage RangeRow4: Volts RangeRow4: Electrical StickoutRow4: Travel Speed ipm mmminRow4: Joint DetailRow1: Manufacturer or Contractor: Authorized by_2: Date: