GridEditor Manual
description
Transcript of GridEditor Manual
GridEditor software User’s guide
First edition
DIGITAL MICROSCOPE
DG-3x
Grid Editor Softwere User’s Guide
2
1. GridEditor software
This software provides seven types of grid patterns as well as the scale patterns displayed in the lower-right position of the screen of Scalar's DG-3. The new grid patterns are shown below. ① Cross ② Full Grid
③ Horizontal ④ Lower Right
⑤ Upper Left ⑥ Rectangular
⑦ H-shaped
Grid Editor Softwere User’s Guide
3
2. Functions
A Settings file needs to be written onto the CF memory card to display grids on the DG-3 display.
The Settings file can be generated and edited with “GridEditor.exe”, which runs on Windows 2000, Windows XP, and Vista
① ② ③ ④
⑤
⑥
Grid Editor Softwere User’s Guide
4
Description of GridEditor.exe
To prepare a Settings file, please select each parameter of each of the magnifications (25x to 1000x). Specify a grid pattern, a color, a grid saving, option, a horizontal pitch, and a vertical pitch as described below: . ① Grid pattern ・Select a grid pattern from the seven types described in Chapter 1 “GridEditor
software”. ・When "None" is selected, other parameters become invalid and no grid is displayed
on the DG-3 screen. ② Color ・Select one of these seven colors (blue, red, purple, green, light blue, yellow, and
white). ③ Scale saving ・When "No" is selected, a grid only appears on the DG-3 screen and will not appear
on a saved picture. When "Yes" is selected, the grid will be saved. ④ Horizontal and vertical pitches ・The interval (pitch) of a scale can be set in the horizontal and vertical directions. ・The value of a vertical pitch is disregarded when the “Horizontal” grid is selected
in Although horizontal and vertical pitch values can be set from GridEditor, we recommend your setting these values from DG-3's CALB function because you can check the grid after each adjustment.
⑤ “File” menu There are 4 options ("New file", "Open", "Save as" and "Exit") from File menu. "New file" ... Create a new Settings file. (All parameters will be set to default.) "Open" ... Load an existing Settings file. "Save as" ... Save current Settings of GridEditor. (The extension of the Settings file is ".DG3".) "Exit" ... Exit this software. Exit only after you have “Saved” your settings or you will lose your choices. ⑥ “Read” and “Write” ・You may read and write a Settings file from/to the CF card. ・Specify the drive name where the CF card is installed and the folder where the
DG-3 images are saved.
Grid Editor Softwere User’s Guide
5
* See also 6-11 4. “Changing the registration folder destination of recorded image (FILE) “on page 19 of DG-3s “Instruction Manual” 3. Operation on DG-3
By accessing the settings file on the CF card, you can select a new grid on the DG-3's screen. ① Switching of display pattern
By pressing the "SCALE" button, you can select a grid from 7 patterns you specified in the Settings file.
② Adjustment of scale width Hold down the “MENU” button when a grid is shown to enter the detailed setting mode. Then, by pressing the “”WB” or the “REC MODE” button, the scale width of each pattern can be separately adjusted. (CALB function of DG-3) CALB HORZ: Specify the pitch width in the horizontal direction by “+” or “-“. CALB VERT: Specify the pitch width in the vertical direction by “+” or “-“. This function is valid only when DG-3 is started with the CF card, in which a settings file was written.